Network Security

I find references to FWSM Software V3.2 but I can not find the software to download it. Does any one know where to locate this? Thanks.

I have 2 3020 Concentrators that are both running the 4.7.2.I Aug 03 2006 16:30:26 code. The issue I am having is that backup will not go into backup mode, but stays in INIT mode. This is due to the fact, whenever I enable VRRP. Save.. Then, come bac...

I have several clients using Pix Tunnels for site to site connections. I have one client who cannot route my internal network address space do to an overlap issue. I have tried to setup the nat, but the traffic is not changing to the NAT address.Here...

Hello everyone,I have some questions that Cisco tech support has not been able to comment upon due to their "Sales" restrictions and product information available.I NEED to know what kinds of hardware VPN routers are compatible with the Cisco 55xx se...

Hi all,May I know if the max. memory on PIX515 restricted version bounded by 64MB? If I want more than 64MB, then I need to upgrade to unrestricted version, right?Thanks in advanceRegards,mak

Hi folks,I have surprising thing when firstly configure IPsec_ra on asa 5510 with asa version 7.1(2). I usually configure this on PIX platform and never failed. I use standard VPN remote access configuration with using provided default tunnel group. ...

Hi, We just had an engineer configure our firewall and now, I can't access inside resources from inside, using the outside IP address. For instance, we have a webmail server with NAT which works perfectly from outside the firewall but if I am inside ...

Hi,I have some problems with vpn3000/NAC. For authentication I use ACS v3.3., users have configured downloadable IP ACLs. All works fine, if there is not default Accsess list configured on VPN3000/NAC tab, which allow EAPoUDP communication between th...

One of my Clients have a couple of Site to Site Tunnels and now they would like to setup a VPN Client as well. I noticed on the Config that the Client is setup however using RADIUS authentication which to my knowledge is being used. I take out the li...

Dear friends,I'm having a issue with my PIX 515E. I'm trying to connect to a external FTP server from a host located on my inside network. The problem is I can connect and authenticate, but no commands work. I got "Invalid Port Command".I tried both ...

Hi,We configure our PIX & ASA installation using both the CLI and ASDM. However, we have recently noticed that certain changes to the config via the CLI are not visible from ASDM (Even after a refresh)Does anyone else configure from both ASDM & CLI?I...

Hi all,I have PIX535 with ver 7.2.2I would know is there any problem on static routes pointing to the same host but in different interfaces?For example,Group A workstations NAT to interface "DMZ1" with 172.16.1.xGroup B workstations NAT to interface ...

As per Cisco DocsMaximum memory supported by restricted license is 64Mb. Does that mean I cannont insall 128Mb module in 515E with restricted license? Or I can install 128Mb module but OS will utilize only 6Mb?ThanksSyed

Hi allI require assistance with configuring an acl on a 6500 firewall inbound interface so a host can access only specific server ip ranges within other siteseg: server addresses 192.168.x.20 to 192.168.x.35 - 0.0.255.15if anyone has experience with ...