Network Security

Hi, I'm fairly new to Cisco Firewalls. My company recently switched from Watchguard to Cisco and I'm trying to configure our newly arrived Cisco ASA5510. However, I'm having some real problems with basic connectivity and configuration of the 5510.I'v...

I want to access my pix firewall from internet with telnet . In front of my pix i have a modem.Modem has 192.168.2.1 and my pix wan interface has 192.168.2.2.I made port forwarding from my modem to pix for port 23 but it doesn't work.Here is my runni...

I have a reverse Nat table in my fix 515E router. There is a line in the config: nat (inside) 1 access-list 100 0 0It appears right up the individual table entry lines for the reverse NAT. Does that line mean I can have only 100 enteries in that tabl...

I have a backbone switch (4507)and ips sensor 4215 which is connected to port 6/4 on the BB switch and i want to make the ips sensor to monitor all the ports on the BB . i found that i must create source span ports on the BB and the port 6/4 must be ...

Hi, Our network is going to be redesigned. We have about 50 employees with remote agents using 501. Our new design will be something like: INTERNET -- ROUTER -- PIX -- L3 SWITCH -- LAN My main problem is that there is another router connected to the ...

We need to connect a remote office which is in another country to our Headoffice in another country. We want to create a tunnel between this two firewalls to allow for the LAN in the remote office to connect to the LAN at the Headoffice. We dont seem...

Any info is appreicated

Hi,Can anybody tell me that does PIX 535 has a Gigabit interface which supports UTP. If no then for connectivity of PIX with any device on Gigbit GBICs are used or SFP.Thanks.Best Regards,Rahim Amir Ali

Hi all,I'm trying an old VMS 2.3 with IDSMC 2.0.1 to IPSMC 2.1 through VMS2.3 CD1, but during the installation process it appears an error telling me that ASANYs_SqlCoreDB cannot be stopped and asking to do it manually.This process doesn't appear amo...

Hello,I need to purchase another pix firwall (already have 501). Was wondering if i could get a comparison resourse some where (need to know the major diff. from 501 to 535). Also the major difference between PIX and ASA.ThanksDaniel

Hi I have a pix 501 and try to connect vpn with a 876 k9 . Can anyone help me to do this tnks !!!

We are using a Pix 535 firewall and we're trying to establish a VPN connection from inside our network to another network. (not site-to-site VPN).This is just a simple connection using the Windows VPN client. On the firewall logs we are getting:Deny ...

Hi,We have tried downloading the image IDS-4215-K9-sys-4.1-4-S91a.img from Cisco site but unfortunately we got the error message... "Error: DB: ip_check :3"Anyone in the forum can share this file.TIA.