Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

HiI have erased the startup config and reloaded ASA 5510. Now its not able to boot preoperlyLaunching BootLoader...Default configuration file contains 1 entry.Searching / for images to boot.Error 28: Selected item cannot fit into memoryunable to boot...

sarat1317 by Level 1
  • 3982 Views
  • 16 replies
  • 0 Helpful votes

I have a PIX 515 running 6.2.2 configured to allow both a lan to lan tunnel and Cisco VPN clients to attach. Both scenario's work fine. The customer is bringing up a remote so we want to use the 831 for this new site in client mode. I have used th...

mwadam by Level 1
  • 519 Views
  • 2 replies
  • 0 Helpful votes

We ran a fiber cable which has 48 fibers between our facilities for many isolated communications paths about 20 miles apart. So we own the cable and it is not shared with anyone. My question is do you feel we should have a firewall on each end? We...

wrwiii122 by Level 1
  • 2110 Views
  • 7 replies
  • 0 Helpful votes

I am looking for suggestions of a good "What To" book for an ASA 5510 box, i.e. something that goes into the features of the ASA and what it can do for me, rather than something that just talks about how to do certain stuff with it. The problem I hav...

ibrewster by Level 1
  • 376 Views
  • 1 replies
  • 0 Helpful votes

i have configured static nat in cisco pix 525.the local ip (machine) resides on the management interface,sec level 95.i have allwoed the necessary traffic from outside to the global ip of the machine.but there is no entry in the xlate and i can't pin...

mulugetash by Level 1
  • 1442 Views
  • 11 replies
  • 0 Helpful votes

Dear Group,I am currently working on L2TPv3 which provides layer 2 VPN and transparently forwards any layer 2 frames from one site of customer to other site over Service Provider's IP network. I want to know that which protocol provides stronger secu...

rmujeeb81 by Level 1
  • 875 Views
  • 1 replies
  • 0 Helpful votes

Last "Patch Tuesday" there was a serious vulnerability reported for Microsoft that could be exploited via an SNMP buffer overflow. But there does not seem to be a Cisco signature yet. Is there any status on this?

rwebster by Level 1
  • 1131 Views
  • 6 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card