Network Security

Is possible Upgrading from 4.1 IPS to 5.0 over ssh? or must it be over console?

I noticed the hard coded speed and duplex settings for interface Management 0/0 do not replicate from the primary to the standby ASA. Do I have to manually hard code these on the secondary? Will the settings keep after the unit restart since it get...

When i click on Query Interfaces (IPS Manager: Configuration > Settings > Interfaces) i get the following error: An error occurred trying to get the interface information. An error occurred while trying to determine the sensor version. Detail = Error...

Hi all,I have very interesting question related to PIX 525. We have sometimes problems with temperature in our servers room and each time temperature rises over 30 C our PIX starts block every traffic and we cannot connect to it via SSH and console t...

I'm searching all over Cisco.com for information on installing CSA 5.1 agent on Microsoft Clusters with Teamed Broadcom NICs, but I can't find any information other than "this is supported" in the installation guide.Does anyone know if there is a pro...

After upgrading to the 5.0.0.186 release, I have several servers that will not remain in thir groups, even after being added to them several times. It seems to happen after they are rebooted. A Critical Error is generated, saying no policies are bein...

Getting error from about 1/3 of agents"Critical The agent software failed to compile the configuration sent from the central server: Timed out after 600 seconds Details"Not sure how to get the agents to update. Any ideas.

Hi. this is a strange one. We have a C7200R (FastEthernet) on one side and a C3500 (FastEthernet) on the other with an IPS4240 in the middle. When changing the IPS unit from "bypass-mode on" to auto the interface on the C7200 router goes down, ie no ...

Should this signature trigger for:GET /\r\nI thought it should trigger for something like:GET /\rHTTP/1.1\r\n\r\n

Problem: A cisco ASA 5520 running slower and slower when surfing. Download speeds are fine.Cpu & memory usage are both low.Suggestions?

I would like to know if I am understanding the vlan assignment in NAC L2 802.1X correctly. As i understand it, once a client has been assigned a "healthy" posture token, they will be put in the "healthy" vlan. Does this mean that every "healthy" user...

A new twist to my ASA tribulations! I made a change to an access-list using ASDM, and it didnt work. As a good measure, since things have been in flux with it, I rebooted it via power switch. now it wont come back up. When I boot, I get the following...