Network Security

I need a configure the IPS send a email when it happens a security event medium or high. Actually I have a Network Monitor System with the Orion Tool (Solarwinds). The IPS can send email independent or is needed to obtain some trap? What I can do?

Every morning I have to issue a clear xlate on our firewall to browse the Internet. Our inbound web servers are not affected. Any ideas on getting a handle on this problem This issue has been a tough nut to crack.

Dear All!When I'm trying to deploy a configuration prepared in Cisco VMS 2.3 for a 7206 router with IPS, the configuration does install on the router, and starts working.However, the deployment procedure ends with the following error: "Unable to proc...

I want to write a simple network management application which can grab the statistics from Cisco router using SNMP.Any body have any experience writing such program?Which pogramming languages should I use? C++/VB,..?

Im having issues connecting my PIX 501 through another company's 3030 to reach their FTP server. The specifics are: remote company outside (peer ip adx) 192.x.3.10local host : 164.72.181.24ipsec settings:3desgroup 2espsha1-hmacIPSEC SA Forced key exp...

Hi all,I have noticed that there is a big amount of questions and troubleshooting issues when it's about combining several PIX features like address translation, encryption ...So can someone give us the order of operation in the PIX for inbound and o...

Hi there,I have been asked if it possible to replace an old 800 series router with a modern pix, i am looking into replacing it with the entry level pix the 501, my question is, the router has 2 ip addresses on the inside interface is it possible to ...

IDSM2 with IPS5.1 (on cat65K sup 720 IOS 12.2SXF) will support ? Inline ? mode.But does it support ? blocking? as well ? ??? CCO document says ?Supervisor 720 with Cisco IOS supports VACL deny statements; however, IDSM-2 cannot block with Cisco IOS-s...

Hi,I would like use netflow on one or two interfaces. But i have a problem, because when i use netflow, i'm all reccords for all interfaces.On the interface, that i want monitor, i use ip flow egress commandthanks your help.

HiIPS version 5.1 was not stable in our network, so TAC engineer gave us a special patch (1p1) and we installed it.This 1p1 was not published on CCO officially.Now version 5.1(2) is out, does anyone know whether 1p1 is incoporated into this 5.1(2)? C...

I have a need to establish a secure tunnel between two sites by using two routers, or two PIX525 firewalls, or two VPN3030 concentrators; the equipment is not an issue. This connection should be functioning as a transparent bridge, so layer 2 traffic...

We are planning to take an ASA 5520 box for with Cisco ASA Advanced Inspection and Prevention (AIP) Security Services Module, already we have 1Mbps internet connection. Now for VPN service through this box, what should I do ? take a new internet conn...

Hello Here's my problem. I have a pptp vpn configured in my pix 506e. I can connect fine and browse network resources on the remote network by IP address. I can connect to any computer using MS remote desktop connection. I cannot browse by netbios na...

HiWe have ICS server installed for a customer using Cisco IPS.We need to email alerts for the customer, however it does not accept the customer's email addresses because there is a '-'!!E.g.It accepts [email protected] but not [email protected]...