Network Security

Hi,I need to stop SNMP Traps on PIX (ver. 6.3(5)), Traps comes from outside to inside, it comes very often, every 5 seconds. I added row to access list on first place:deny udp <source IP> <destination IP> eq snmptrapBut hitcount is only 29, and SNMP ...

Hello,Has anyone ever seen the following message when attempting to add an SNMP host on an ASA/PIX..??"IP and subnetmask form invalid pair indicating broadcast or network address"Here is what I am trying to enter..."snmp-server host OUTSIDE 1.x.x.43 ...

Hi,Currently my Cisco CSC-SSM is online with TMCM 3.5 using MCP.I was unable to login to my CSC-SSM module MANUALLY (without SSO)through the TMCM3.5 even though I have provided the right credentials. Could anyone advice me how to troubleshoot this ma...

HiI have a backup pix of 515E. Same configuration of existing one. When disconnect the live one and connect the backup one then able to go outside except the m/cs which are mapped with public ip.help [email protected]

Hi,Whenever we apply the signature update to IPS 4240, it reboot itself normal but gives an error after enter the username/pasword by using ssh; and not enter the CLI. "Error: Cannot communicate with mainApp (getVersion). Please contact your system a...

How can I configure DFM 2.0.4 to collect config from device when config changes, immidiatly?thanks!

We have pix 515E with FOS ver 7 .We would like to know how to ping the outside interface from a host on the insideThere is NO nat-control and even after we gave icmp permit any any on the outside interface and inside interface the inside hosts whose ...

I use my router itself as a DNS forwarder. Unfortunately when a domain query is requested on the LAN side, the packet is sourced with the ouside interface IP address which is ouside the EzVPN tunnel and thus the reply does not find it's way back. Can...

I'm having a heck of a time getting my 871W router to do a simple dhcp binding. I want to set up dhcp binding so I can use dhcp on the client machines, but always know the ip address so I can use monitoring software or web/ip connections to fixed add...

HiPix model: 515EOS Version: 6.3(3)Trying to connect through consule. System stuck after the following msg:CISCO SYSTEMS PIX FIREWALLEmbedded BIOS Version 4.3.207 01/02/02 16:12:22.73Compiled by morlee32 MB RAMPCI Device Table.Bus Dev Func VendID Dev...

Dear all,We are using NIDS - 4250 for the last 15 months.We are continuously monitoring its disk & memory usage. We found from starting the memory usage is increasing normally & gradually(1% in 40-50 days). But for the past two months we are finding ...

The ASA was configured and I was working remote through SSH and Telnet.Without any messages the ASA doesn?t respond any Telnet and SSH request, and I tried to go with ADSM tool and I got the following messages:"ADSM is unable to read the configuratio...

I can?t connect to console in a ASA 5540.I was working checking some configuration lines and I got disconnect and now it?s impossible to get into.is there any way to get console without reset the ASA ?