Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

I have a PIX (we'l call PIX A) which has a VPN (PIX TO PIX) connection running to PIX C. I have tried to set up a VPN from PIX A to PIX B which has not been used for VPN. And I can't seem to get ISAKMP to 'start' between even though I've copied the...

I have this sensor doing tcp resets, the question I have is if I add a network to the "never block addresses" will the sensor still send tcp resets even though the network is in the never block? if so how do I tell the sensor to not block certain ip ...

Hi all,We just replaced our pix 520 with 6.3 with a ASA running 7.02.We experienced a lot of problems with FTP connections.I had to allow source port's 20 and 21, on top of the normal rule who allows port 21.The control channel was no problem, but th...

SDWorx_2 by Level 1
  • 497 Views
  • 1 replies
  • 0 Helpful votes

Hello everybody. I need help I have taken connection from ISP the ISP provided us VERILINK router our internet is working fine.I have purchased Pix firewall i would like to use PIX firewall on my network. Can anyone provide me the configuration to co...

ciscomoon by Level 1
  • 682 Views
  • 10 replies
  • 0 Helpful votes

i just want to ask how is the IPS funtionality works on ASAs. Does it have all the signatures or it is limited?Coorect me if Iam wrong if i say I needed AIM module for ips to work on asa. If Iam right, then why the AIM module has only 1 ethernet int...

I've installed ASA5510 with AIP10 at our client site. But I have 2 problems.Firstly, I can't see any traffic from giga0/1(backplane interface) of AIP10.Should I configure related configuration at ASA5510? I already configured related configuration at...

skytosky by Level 1
  • 947 Views
  • 4 replies
  • 0 Helpful votes

Hi,I have a question about Active-Active configuration in PIX Ver.7. After configuring my primary PIX FW with 2 security contexts and with 2 failover-groups, and after applying the needed configuration as illustarted in the online config guide, I con...

Hello, for the last week or so since we put in a pix 501 (6.3.4)with a 10 user license there has been at random times one PC (not always the same one) which cannot access the Internet on a LAN with 12 computers. The last time this happened I checked ...

pmacdanel by Level 1
  • 687 Views
  • 3 replies
  • 0 Helpful votes

pls I discovered the following error message in my pix 515 pdm"[ERR] pdm location x.x.x.x 255.255.255.255 dmz **** WARNING *** Configuration Replication is NOT performed from Standby unit to Active unit. Configurations are no longer synchronized."Als...