Network Security

Hi,I have am a complete beginner with the pix 501 box. We currenty have two sites running a vpn via the pix 501 boxes.Firstly, our internet connection goes down appox every 2 hours, the only way restablish the internet connection is to reboot the pix...

I have two 3845s running IOS security, configured with HSRP for redundancy.At the moment I am having to duplicate the ACL entries on both routers.Is there a way of having an ACL change made on one router sync'd(copied) to the other?

When I try to view the events, I receive the following error "no record found by using current filters in table view" and then it list the table I was trying to view. This was working until about 1 week ago, not sure why it quit working. Any ideas?

I am upgrading out IDS 4210's to IPS. In the upgrade process I keep on getting an error on two of the IDS saying. “This does not appear to be a valid IDS Platform". I know they are valid. Your help will be appreciated. I am using IPS-K9-maj-5.0-1-S14...

I have a customer that has two isp connections and is looking for bi-directional redudancy. (Inbound and outbound). Currenly have a Cisco Pix 7 with 6 interfaces total. I have used devices in the past from Fatpipe and Linkproof that provide this func...

Hi,I have a central PIX 515E with version 7.0. I am trying to connect two remote sites through VPN with the same IP range (192.168.1.0/24) on both remote sites, to the central site which has a different IP range.Is it possible to do all the translati...

I would like to use the PIX 501 firewall for the following purposes, but not so sure if it can handle them:1) support 3 interfaces: inside, outside, and a DMZ? 2) Remotely configure/maintain the firewall using command-line interface (CLI) via VPN?3) ...

Have an ASA 5520 at one site with remote client VPN configured. Works well for remote users. Using a VPN pool that is never fully utilized.Our problem is that when users at one remote site use the Cisco VPN client to connect, only one connection is s...

I have a PIX 515 with 16F/32M that I am trying to upgrade from 6.1.4 to 6.3.5 I can copy the image from the tftp server and the pix will then reload. It gets stuck in a reload loop. I can get to monitor mode and restore 6.1.4 successfully and it rebo...

I am running IPSMC 2.1 with Sp1-6, I am trying to upgrade 4.1 sensors from the IPS mc and they fail. I am upgrading by going to <configuration->updates->choose->IPS-K9-maj-5.0-1-S149.zip>It fails each time with the following error:An error occurred w...

Is there any documentation that explains the anticipated behavior with a sensor that has the same suspicious traffic pass by (promiscuous) or through (in-line) interfaces on the same sensor?The new Cisco IPS course materials has one short note: If th...

We have 4 6500 IDS blades running 4.1 on native ios, I'm looking for step I need to config these. Any help would be greatly appreciated.Thanks

hi,I'm installing CSA agent on a Linux server and the install tells me, that the kernel version is too high! Which versions are supported yet and what version support is expected? What can I do?Thx