Network Security

Hi allIs it possible to use WebSense with the PIX without ACS and still do user/group based policies?The only document I can find referencing a WebSense/PIX setup is this one:http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note091...

I was able to access the vpn concetrator using https session on private interface. After I save the config file or did something. When I do http I am getting webvpn login screen littile different than the one thjat i was getting. The other one had vp...

Has anyone had problems with the upgrade to IDS MC 2.0? I installed this on my testbed and the Management Center came up okay, but the Security Monitor would not come up. I re-installed it and nothing would work.Any suggestions would be greatly appre...

Hi everyone. I have a scenario where I would like to forward all smtp traffic out one gateway, 1.1.1.1 and all other traffic out gateway 1.1.1.2.The PIX is connected to my internal network, 10.10.1.0 and there is a static nat translation for host 10....

Whats happened with IDSMC 2.0? it was removed from download center.

%VIP4-80 RM7000-3-MSG: slot0 VIP-3-MVIP_CYBUSERROR_INTERRUPT: A Cybus Error occurred..Dec 17 21:31:52: %VIP4-80 RM7000-1-MSG: slot0 CYASIC Error Interrupt register 0x8.Dec 17 21:31:52: %VIP4-80 RM7000-1-MSG: slot0 Parity Error internal to CYA.Dec 17 ...

I have a client that sits on the inside of my PIX, and is trying to pass a proprietary Checkpoint tunnel through my PIX to his office with another Checkpoint their. He uses port 18192 and has a Checkpoint NGAI on both sides.I have setup a static nat ...

Is it possible to set a priority to traffic on the pix either by IP or protocol? And if so is this possible through VPN? I have a video conferencing traffic I would like set priority for. Thanks

I'm wanting to separate my switchports logically with VLANs and I'm wondering what my configuration should be.For each interface that I want to communicate I will run the below command in interface configuration mode.switchport access vlan 7I will do...

I have installed a Linkproof to do load balancing, behind that i have a fireproof with 2 cisco pix 515e, my vpn clients loose conectivity to the internal network and the only way that it gets fixed is by doing a reload on the pixes. Has anybody worke...

I have a PIX515E running 6 interfaces, I have a DMZ interface with a Server running IPSwitches WS_FTP Server on it. I have a Static NAT from the outside to a Public IP address. The FTP Server is truely set up on a private IP address on the DMZ interf...

Is the IP protocol version 6 supported in Cisco Pix 515 UR ?If yes, is also IPv6 support in Cisco 515UR+FO4 ? (it it possible to make also IPv6 with the FO4 ethernet extension?)

How can I open a port on a Pix 501 ? I tried to add a access-list with a port number. After that, I tested it with a port scanner and the port is not open. I thought that adding an access-list will open the port.Thanks !

I am having an issue where all wanted traffic can get in (Webpages, DNS, SMTP, etc.) but no machine from the inside can get out....even with a ping.I attached my config,When I try to ping to the outside from inside, I get this error logged...305006: ...