Network Security

Hi guys, mind looking at my config and helping me figure out why any box in the DMZ can not be accessed from the outside.. They also have no access to the net? I looked at couple example configurations and i must be missing something every single tim...

i understand that ospf is supported on pix 6.3..But how it is implemented..i couldnt see any sample configurations or even documentaion guidelines on how to implement it...anyone could suggest any link pls will be greatly appreciated.

I have a PIX 506 that was connected to a ISDN with a static IP. Now we went to ADSL and we don't have a static IP. Is it possible for me to set the outside adapter to DCHP and have it work correctly? From the limited reading I don't think it is posss...

I'm trying to connect a PIX FW and a VPN 3015 with the use of certificates.I followed the instructions found in TAC, but at a given moment there's a command that configures your CA server to get the certificates, and it's here that it goes wrong.--> ...

Hello,I want to configure the pix to redirect the trafic in one external ip to different internal ips depending of the port requested. I have tested it using static command and has worked with some test but when I change the ports to the real ports t...

I have a VPN Tunnel from PIX to NMS-DMZ.now i want to enable logging on the PIX (on the same as the Tunnel starts) to the NMS, but it seems that the packets are not entering the tunnel. how can i route the Packets into the tunnel?thanks Phil

I have a server with real IP 90.0.0.50 has Natted to 172.20.1.1 as follows;static (inside,outside) 172.20.1.1 90.0.0.50 netmask 255.255.255.255 0 0 If I want to allow 172.20.7.0 network to access server network , what is the correct IP to be defined ...

Hi All..Am trying to setup a remote site using a Pix506e on the remote end and a 3005 Concentrator at the headend. I am getting an error on the pix that says "VPN Peer: ISAKMP: No remote peer info for 12.109.169.12/500 - peer:0" That IP address is ...

Hello .. Is there a way to do simple URL filtering on the 501 without the use of websense or similar external products? I have searched through the postings in this forum but have been unable to find anything similar?Basically, using an acl or equiva...

Hi,We would like to use object group in our PIX configuration. Can you please let us know what version of software we need to upgrade the PIX to achieve that? Currently we are on version 5.2(5).Thanks.

We have a Pix 506 that has a VPN connection to a PIX 520. There is one client on the 520 side that loses the ability to connect to the data server on the 506 side of the network. All other hosts can communicate accross. If we remote to a pc on the...

Is there exist any command to reset the blocked connections in PIX-515E ver 6.2 ?

Is there a command on pix (v6.3.3) that would give a list of services (eg:http server) currently running on the pix? The "show service" doesn't really say much....thanks.

Hiaccess-list 101 permit tcp any any eq domainaccess-list 101 permit tcp any any eq 8080access-list 101 permit ip host 192.168.0.250 anydialer-list 1 protocol ip list 101The above ACL works fine if the router(801) is directly connected to the switch....