Network Security

Greetings,I have 2 ISP handoffs w/ different public ranges and a single PIX. Static routes.I would like to be able to route traffic from the INSIDE network through one ISP and the traffic from the DMZ network through the other.Can you suggest a route...

I need to backup the image file of a Pix firewall. Copy command only allows upgrading image files (copy tftp flash). I would like to backup the image file of my pix to a tftp server. How can i do it?Thanks a lot

Hello, I am trying to set a vpn from a 805 (12.3 with ipsec 3des) router with dynamic ip to a 515 PIX Fw (6.2) with static ip. Seems that there is a easy way to do this if you use Easy VPN like the example in this link http://www.cisco.com/warp/publi...

Hi,Have a 501 which can not even ping a dsl router; the int eth0 shows up up. I also connected a laptop to the dsl router and assigned myself a public address and I get the connection right away.Has anybody experienced this situation?I have configure...

PIX code 6.3(1).I have 2 T1s through 2 2600 routers from 2 different ISPs. Can I load balance traffic through the PIX, using OSPF, over equal cost routes? I would setup the 2 fa0/0 on the routers in front of the PIX and the outside interface in the s...

I have a pix 515, on a flat 192.168.1.x network. The pix inside is 192.168.1.1. I have another router, 192.168.1.2 where I want to send the network 192.168.2.x traffic to. I put a static route:route 192.168.2.0 255.255.255.0 192.168.1.2 1It will not ...

Anybody here know if the "ip verify reverse-path" commands are enabled by default for this release? I just noticed these were on when I upgraded the OS.TIA- Jericho

I'm doing Video conferencing thru ADSL connection using PIX Firewall 6.3 and doing PAT.Do I need to open any ports or by default it already open by the standard fixup port?

Hello,We currently have an ADSL connection with a ZyWall firewall with has limited upstream bandwidth. What we would like to do is to get an additional SDSL connection with 1MB in both directions that we can use just for hosting our mail server/vpn u...

I have a Pix 515 with 3 interfaces. Interface 2 has a workstation that will need ot join a domain with the server living on the inside interface. I have port 389 allowed but it doesn't let the client join the domain. Does anyone have a suggestion as ...

I have a client which access a server through Exceed application which uses UDP port 177 and gets a reply from the server on UDP port 6000.How do i configure this through PIX firewall.The Client is on inside interface and the Server on DMZ.RegardsPat...

Hi!Is it possible to configure the PIX in order to block users from downloading files from the Internet?I mean, I want to allow them to browse the web but no to download any files!Thanks!

Hello, I have a client that has a Pix 515 firewall and I have a Watchguard Firebox 1000. He gave me the Cisco vpn 3.5 software to install. My question is, what ports do I need to open on my firebox to allow outbound and inbound communications to his ...