Network Security

Hi All,Our PIX connects to a two Outside routers that belong to Company C. Two routers of Company C just provide redundant paths. All company C's routers, including the two that connect to our PIX, run EIGRP. I have following questions:1. Can we use ...

Is this supported on pix? I know there's a feature (vpnclient) in 6.2.2 that can make the pix act as hardware vpn client. but that only works with cisco easy vpn server on the other side and expect to receive the proposal from the server.Im looking f...

Is NBAR or a similar technology supported on the PIX? And can it be used to limit bandwidth used by the apps but not block the traffic completely?

I have a pair of PIX 515's operating in failover.IOS 6.1(2)The failover has stopped working correctly.The primary has to be re-booted to resume normal operation.Following re-boot sh ver indicates that the firewall has been up for 23 days, when clearl...

I run a hub-and-spoke architecture network that uses two different VPN technologies to connect the spoke sites to the corporate hub. Some spoke networks use Windows NT RRAS and the other spokes use Red Creek Ravlin VPN boxes. All users are routed to ...

Hi, I have a pix 506 running ver 6.2(1), PDM Ver 2.0(1), 8Mbytes Flash, 32Mbytes Ram.After some configuration change (3DES VPN) via telnet when I try to use PDM I receive the following error message:Unsupported CommandsThe Cisco PIX Device Manager (P...

Hi togehter,how can I change the default ssh/telnet username "pix" to another.The passwd change is no problem, but i cannot find any cmd to change the default username "pix" to another.any ideas ??sascha

Hey Folks, I've run into an odd problem on my PIX's (tested on 501's and 506e's). I have a fairly large network of VPN offices that have PIX 501's (all running 6.2(2)) setup as DHCP servers. I've noticed that my office's Neoware and Viewpoint Thin Cl...

Friends,I have the following config:PIX 525 (5.3)fixup protocol ftp 21static (inside,outside) publicIP privateIP netmask 255.255.255.255 0 0conduit permit tcp host publicIP eq ftp anyconduit permit tcp host publicIP eq ftp-data anyI think those are a...

I am looking to deploy a PIX with the inside interface facing outside to allow for DHCP addresses to be assigned to Wireless clients. I will be deploying ACL's to restrict access on both interfaces, but am looking for confirmation that there will be ...

when I add pix to a network,it complains "your ip address can't be the same to your gateway address" when I set its outside interface ip address using 'dis conver interface settings',but I can manually set it .what is wrong ?for example, when I add p...

Hi,How can I log who connects to my Cisco 827 (C820 Software (C820-K9OSY6-M), Version 12.2(8)T4)I tried "vpdn logging user" but no success...I can only see when the Virtual-Template interface goes up and down(logging with syslog server)Please help.P.

I can't seem to think of the best way to phrase this so please bear with me.If I put a fluke on a network it appears to show that 192.168.255.255 is the address the pix is using. There are two 515 with failover between them (if it makes a difference)...

Dear all,I have failover 515 Pix, the logging configure as follows:[logging onlogging standbylogging buffered debugginglogging trap debugginglogging host inside 210.177.52.33]in pix menu, if logging standby will created doubles the amount of traffic ...