Network Security

Hi,we have a special Problem with two 3060 and load-balancing. both boxes are configured to load-balance. everything works fine with the cisco VPN Client.but the load-balancing doesn´t work with the windows xp vpn client.Is there a special setting on...

How can I change "enable", "telnet", and other admin passwords for PIX 515 without locking myself out. Thanks

What is the command to see what IP address has been assigned to the PIX when attached to a cable modem?Thanks

Can PIX be used as a default router for hosts that need to reach other internal networks? Access to these networks is through a router connected to the inside subnet.Does PIX support ICMP redirects?Jarek

I have VPN Device Manager installed on 1710, 1721 & 2691. In all cases, IE6 with JRE 1.3.1_02 & JRE 1.3.1_07 does not display correctly. Since JRE 1.3.1_07 seems to be the default with XP Pro & IE6, this is a problem. Some earlier JREs work ok.Is the...

Greetings,I have a PIX 515-E UR-FO bundle running 6.2(2) that's failing over when it shouldn't. Originally I narrowed down the failing over to right after I do a write mem but since then it's happened outside of that scenario as well.I'm doing statef...

We have a Pix 515 firewall and when we are outside the office, we start the Cisco vpn client to have acces to the LAN. In the LAN, we have a Windows 2000 Terminal Server. We can have access to this server from outside the office very easily by starti...

hello, we have one PIX 535 6.2(2), one DMZ, one ISP and one internal network. And we have a new requierement: to create a new DMZ and to permit acces to this DMZ through a new ISP that will be attached to "other" external interface of the PIX. So, th...

Is the following combination listed below is supported by PIX 525?2 gigabit card + 1 x 4-port 10/100 mbps card(This will give me 6 10/100mbps port & 2 gigabit port.)i know it can support up to 3 gigabit card or 2 x 4-port fast ethernet card but I am ...

Looking for the most secure way to allow FTP transfers through our corporate Firewall.Right now if an FTP is initiated from the inside network . . . we can connect to the FTP site and login but cannot execute commands like "ls -al" or actually move d...

Hi,I just wonder how to restore pix config file after config file is saved to tftp server thru PDM. Is there any other way to restore it other than copying and pasting config from console mode/telnet/ssh. I reallyt appeciate your comments on this. Th...

Has anyone experienced this? While connected through the 3005 (no split tunneling) and trying to launch SMS admin console, it is not able to connect to the site database. If I go through MS VPN it works fine. Not sure if this is a netbios issue or no...

Hi everyone. I have a vam module in 7200 router and CiscoWorks VMS 2.1. Our object is that remote isp users communicate with company internal lan through the vpn technology. at the first, where can i register id and password for remote isp users? the...

Is there a way to configure a PIX 6.1.x to get its clock from a NTP server ?thanks