Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

I can not get a copy of my PIX config sent to our TFTP server. Other routers on our LAN can.TFTP server is TFTPd32 by Ph Jounin running on a WinNT 4.0 SP6PIX is configed like this.tftp-server inside 192.20.6.8 pixwcimageWhen I issue a 'wr net' of cou...

fbtech by • Community Member
  • 3439 Views
  • 1 replies
  • 0 Helpful votes

I'm wanting to use the PIX 520 (Main Location) and the PIX 501 at my remotes to initiate VPN access to the main location. I'm running IOS version 5.1 IPSec with 56 bit DES on the 520. If I decide to buy the PIX 501's, will I need to upgrade the 520 t...

ehavard by • Community Member
  • 1183 Views
  • 1 replies
  • 0 Helpful votes

Currently running - Cisco Secure PIX Firewall Version 6.0(1)What version should I move too, 6.1.1 or 6.2.1 ?Pix infoHardware: PIX-525, 256 MB RAM, CPU Pentium III 600 MHzFlash E28F128J3 @ 0x300, 16MBBIOS Flash AM29F400B @ 0xfffd8000, 32KBLicensed Fea...

k.terrens by • Community Member
  • 1130 Views
  • 1 replies
  • 0 Helpful votes

Hello Cisco peopleWe are using Web Sense to block most of the Sites that we feel necessary but have had problems with programs like AOL, MSN, ICQ chat programs. So I am going to stop this at the PIX and was wonder who out there had blocked Chat progr...

rmears by • Community Member
  • 1574 Views
  • 3 replies
  • 0 Helpful votes

I have a H323 terminal behind a PIX 501 with a static mapping to the terminal. I can access the web interface of the terminal from its outside IP, but I cannot make or receive a Video call. I've enable "fixup protocol H323 1720" and I've even tried t...

pcarter by • Community Member
  • 1413 Views
  • 2 replies
  • 0 Helpful votes

We all know that PIX (we have a 525 with 10 interfaces) neither doesn't act as a router nor forwards multicast traffic. That's it. But what about if I need to pass multicast from an interface called private (security 80) linked to a layer-2 switch (V...

dgnaccar by • Community Member
  • 1499 Views
  • 3 replies
  • 0 Helpful votes

I don't know if anyone else has noticed this but, I upgraded our PIX to 6.2 yesterday and the syntax of the Conduit command seems to have changed slightly. My Conduits from the previous OS were not taken and I had to recreate them all changing the sy...

johnbroadway by • Community Member
  • 1652 Views
  • 5 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card