Network Security

I'm trying to get through my PIX 501 from the outside to an FTP server on the inside. I believe that I am using the conduit command correctly and I also believe I have used the access-lists correctly. No matter what I use it will not work. I think I ...

I am using a pix 515 with Cisco VPN Client Ver 3.5.2. Clients are win xp and servers are winy2k. I can create a VPN connection and authenticate through our radius server but cant browse the network........(i know there are tons of threads on this boa...

Has anyone had a problem with a PIX crashing using a Websense server for URL filtering?

I have one pix 515 and need to set up multiple vpn tunnels to different companies. All requests will be initiated from within my network. I have successfully set up one VPN with this PIX, but how do I configure multiple VPNs?

I want to connect multiple ISP's (three) connected to PIX outside interface for differenciated service.These ISP's will gice me three different blocks of IP addresses.I can do NAT with three different IP pools. But, how can I create multi-homed netwo...

Hi everybodyI'm trying to configure failover in two pix 515E following the instructions of the Installation Guide. I've connected the failover cable properly (not using Stateful Failover) but when I write "show failover" in the CLI of the primary uni...

Hi,our need is this: To allow access to a TS server when requests for 3389 are sent to the outside of the PIX. To direct all other traffic (VPN/Email/FTP etc) to our existing authentication server. I have updated the PIX software to allow port redire...

I was wondering if the metric keyword in the statis route command for the PIX works lik a floating staticThanksHarris

I am in need of some real help here. I have to setup a Cisco Pix 501 firewall at work. First I guess it would help to know my setup and what it is that I would like to do:Cisco 678 router is my gateway 65.xxx.xxx.14then I want to have the following d...

Hi, I heard that with the latest cisco ios 6.x we could map a single private ip address with many private ip address like we do nat overload in the cisco router. Is it true and if so how it can be done. Thanks in Advance J.Karthik

I have not been able to find anything allowing me to perform the following.I need to PAT a subnet residing on the outside interface when making a connection to a specific host (host A) reacheable via the inside interface. I don't want the outside add...

Can you suggest a method to configure the PIX 315e firewall to handle Internet (VPN) connections and at the same time allow us to utilize our Public IP addressing scheme for our interion LANs (i.e. 130.xxx.xxx.xxx)? The Internet host PCs will utilize...

This question is a little bit odd, but I need the answer. I have two external interfaces on PIX (extranet1 and extranet2) and one route for the network 192.168.1.0 pointing to extranet1. That is OK. Now, I need to route traffic to two hosts which are...

One question it is posible to separate 2 networks with a PIX Firewall ...????There is not a routers only switches...

Hi Everyone, have a question, I have 3 different subnets from my isp. What I need to know is if the pix can handle the 3 different subnets or do I need a pix for each subnet. I want to disable nat, and have the machines using external address, with a...