Hi!OK, clearly I am in over my head here. I am trying to do a port forward for Plex running on a NAS inside the 5505. I have tried tens of different ways, and now I have run out of guides... What is the smoothest way of doing a port forward?David
Forum Posts
Hi, I needs experts advice as I have issue of url filtering configured on FMC under mandatory category. I have rules setup and action allow but its not matching traffic. below is my scenario. Rule - 1 : Adult/Gabling Categories - workingRule - 2 : U...
Resolved! FMC & ASA Firewall Licensing
Hi, I have 8 x Cisco 5516-X Firewalls running ASA with the Firepower Service Module added and 1 x FMCv. Software versions:ASA v9.13(1)ASDM v7.13(1)FirePower Service Module v6.3.0.4FMC v6.3.0.4 I have the following licences registered to my Cisco acc...
Resolved! ASA NAT statement "Original"?
Within the GUI, if you choose under the Action:translated packet Source NAT Type "Static and both source address and destination address "Original" what is that really used for if you are just natting to same original IP?
i have a asa 5515 v 9.1 , i have a S2S vpn IKEv1 and IKEv2 which i need to check packets going through it and what packets getting dropped through it , how can i do that? i cant seem to get anything through asdm real-time log viewer?
ASA 5512-X: How to verify the firewall fails closed if the filtering function becomes nonfunctional?
This firewall does not have FirePower or any other services. It is just the ASA itself. I need to verify some security requirements and I can't find cisco documentation that states if this is a default configuration or how to change/verify it myself...
Hello all, I am having a strange issue with virtual FMC which is managing ~10 FTD firewalls (some of them being offline at the moment) - if I display connection events I see all of them as expected....however if I search for events matching specifi...
Dear all, We have ASA firewall which we have admin access (ssh and asdm) via TACACS+ servers in ISE (10.7.1.17, 10.7.1.18) We configured the following on the ASA: Today we performed an upgrade on the ISE and we rebooted the 10.7.1.17, for around 6 mi...
Hi Guys, We have one pulblic ip address and two web server located in DMZ zone. We want to configure load balancing or load sharing for server availability. Kindly suggest how can we configure load balancing for web servers on ASA 9.6 without any lo...
Hi, I have a firepower 4110, Can someone guide me that which version of FXOS is supported for mentioned FTD version 6.2.3.13?
Resolved! FTD management interface on FP2100
Hi, We need to setup an FMC on a different subnet than the FTD management interface so I will configure the gateway on this interface to reach the FMC. At the same time, the management interface will be connected to the same network than the producti...
Im trying to restrict access through my ASA from several countries. When I test the ACL using my IP I lose ping ability and access to resources as I should. However I can still ping the outside interface and initiate an anyconnect connection. access-...
Hi, Can we get feature on FTD2120 NGFWs for PAN Regex pattern recognition.This is what need to enable. Can this be done through IPS ????
Resolved! Permit before deny Cisco ASA
I am adding a ACL rule on ASA, but when I do that, it goes at the bottom after the deny statement, the only way I can move rules is using ASDM So, how can we do that using in cli when adding rules before deny statement- All the line number before 186...
I was able to get this going after a few packet captures and figured out the issue.
