Hi,I have rule 23 that allows all private IP address (IPv4 RFC1918 group object) to use ICMP and use TCP port 49 for TACACS+ to a specific IP (let's say 10.10.10.31). This rule seems not to work as I get the below result from a packet tracer on the F...
I'm trying to configure netflow exporting through a route-based site-to-siteIPsec tunnel on a Cisco ASA 5512 V9.9 device. Neither the CLI nor ASDM will let me select the VTI as the interface to use for the netflow collector. Is Flexible Netflow requi...
Hello Is there a way to write custom SNORT rules (for IPS) and OpenAppID scripts(for a new Protocol or an APP) and use them in FTD or Firepower Services?Links would be appreciated.
When using the ASA as a DHCP server, it is limited to 256 hosts. Does the FTD have the same limitations? The mask can be 255.255.255.0 or smaller. Thanks in advance!
Any ideas why I cannot SSH from any clients on the 192.168.68.0/24 network to the inside interface IP of the ASA?namesname 192.168.68.0 Net-NY2-SERVERSname 192.168.168.64 Net-NY2-NETWORKip local pool temppool 192.168.0.10-192.168.0.15!interface Gigab...
Team, We currently have about 40 sites, with each one of those sites they each have their own domain and are split between 5 different FMCs. Each site has either 1 or 2 "Internet" connections, with at minimum one of those connections is back to the "...
I have down loaded the new tool. It will not open in a Chrome or any browser. I had no trouble with v1.0.1 Anybody else run into this?
can some please help me with this issue ? asasfr-boot>system install ftp://10.30.2.40/asasfr-sys-6.2.0-362.pkg Verifying 111Upgrade aborted. ASA-5525-1(config)# SH RUN BOOT boot system disk0:/asa981-smp-k8.binboot system disk0:/asasfr-5500x-boot-6....
RSA Netwitness SIEm and Firepower FTD - Logs unreadable cannot integrate with SIEM?Is there a solution to this or a configuration guide?
I have one doubt, do I have to clear the interface statistcis "clear traffic" and then take the output of "show traffic" or its to take without clearing the traffic.Below chart displays the throughput calculated without clearing the traffic rates -...
What is the exact use of nat traversal .Can anyone explain with a scenario.
Hey Champs, I just started to working on a cisco environment and I need your help for Cisco Secure ACS and Cisco Prime Infrastracture tools. How do I learn it.? Please share me the related docs file or any other materials to learn those things in eas...
Hi All, I'm currently writing a migration document to move from SOPHOS UTM to Firepower and i'm getting a little confused with Firepower NAT.Lets say i want to configure what i used to call a "masquerading" rule (NAT Overload or PAT)I create a Dynami...
So if you currently have an IPSEC tunnel allowing 10.10.10.10 to remote host 20.20.20.20 and need to allow more hosts to access 20.20.20.20.Would natting lets say the additional hosts you want allow let's say 50.50.50.50 from Inside interface to 10.1...
Sometimes I only get data on Egress interface.I use let's say 10.10.10.10 as source host to 20.20.20.20 destination on both the Ingress and Egress parts of the Packet-Capture filter in the ASDM.I will only get data captured on Egress interface. Known...
