asa firewall, inside interface,security level 100, test interface,security level 40.there is no access list on test interface.depend on default rule, level 100 can access level 40. why unable to access?thanks
Forum Posts
Hello peopleI have problema, I want to monitoring 2 firepower 4120 with ASA virtual but I cant find the correct OID:CPU.1.3.6.1.4.1.9.9.826.1.66Memory.1.3.6.1.4.1.9.9.826.1.50Cluster. Active/Standby (from ASA)Fuente de poder.1.3.6.1.4.1.9.9.826.1.2St...
Resolved! Block Traffic of MPLS on Cisco ASA
Hello,I have a CISCO ASA to get Internet, some VPNs, etc. and I have a MPLS to connect other Location, I want to Block certain traffic on this MPLS through the FW, but it seems that the ACLs that I created under ACL Manager are not working, the traff...
Just purchased a Firepower 1010 device. Any issues deploying the config? It appears like it deploys and then still has items left to deploy. It never clears. I'm using the FDM to configure it.
Resolved! ASA FO Standby IP address
Hello,I was hoping to get some input or any ideas/thoughts regarding a strange issue we are experiencing when trying to access a standby unit via ssh or asdm.I've configured two ASAs on FPR2110 in a FO and the FO is working as expected.I only configu...
i need to move asa 5520 9.1(7)11 config onto fmc , for the natting i have many natting rules on the asa that doesnt change the source or destination ip and im puzzled whether i need to move them or not into fmc?
I've got a new installation with a 5505. Besides the firewall, I have a router on the internal network which connects us to other offices over MPLS. With my existing configuration, users on the inside can access the internet but not any of the other...
Hello, I have a pair of Firepower 2110 and in the network I use Skype for business.I often have disconnections of the clients on the PCs. The clients communicate through internet to register. Sometimes this communication is not successful, so the cl...
Hi! We just bought Cisco 5516-x with FTD preinstalled on the device. We already have router/FW from another vendor and want to replace it by NGFW from Cisco. I start configuration of Outside interfaces and noticed that ASA doesn't support multiple IP...
hello, I want to know the command to disable tftp-server.and I want to know information about the commands in a captureIs this different from the no service tftp-server command?
Hi, I would like to know if this is possible to configure multiple public IP's to single private address using ASA 5515? Please advise. If yes, please let me know how to configure it the easiest way
Is there any Cisco document available describes that FTD/ASA has some default configuration that prevents it from different attacks?
I purchased 2 FPR-1010 I need to use FMC to configure these devices as the WAN is PPPOE and that configuration is not supported by FDM I installed FMC 6.4.0.3 for VMWare but now is complaining about a license How do I get a license for FMC ? I pres...
I have Cisco ASA 5516-x in Active / Standby failover. I upgraded the Firewalls using the following method: 1) set boot image2) reload standby3) make standby as active (now on latest code)4) reload standby (former active)5) no failover active on 'acti...
After reading though and implementing many of other configuration suggestions from community page posts related to the same issue as well as from config guides and other related pages, I am still having an issue with pinging from my Catalyst 9200 swi...
