02-14-2003 07:32 AM - edited 03-12-2019 10:41 PM
I have 8 cisco AS5200's with non mica modem cards
all running IOS version 12.0 (25) (as they only have 8 megs avail for flash) when ever i put in only one tray of modems they load fine no matter what slot, however when another modem shelf is added it gives me the following message:
%MODEM-1-BADMODEM: Modem (2/23) failed initialization (ATH command)
(it does it to all the modems)
alone both modem trays load fine, just in a 5200 together it throws a fit...i have 16 different trays and have tried all combinations in all cases so i am SURE this is a config issue but cannot for the life of me figure out where or what is wrong below is the config
version 12.0
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname Typhoon
!
aaa new-model
aaa authentication ppp default radius
aaa accounting network default start-stop radius
enable secret 5 (*****removed***)
!
username (*****removed*****)
modem country micromodem_hdms usa
ip subnet-zero
no ip finger
async-bootp dns-server 168.215.178.11 168.215.178.12
isdn-switch-type primary-5ess
!
!
Controller T1 0
framing esf
clock source line primary
linecode b8zs
cas-group 0 timeslots 1-24 type e&m-fgb
!
Controller T1 1
framing esf
clock source line primary
linecode b8zs
cas-group 0 timeslots 1-24 type e&m-fgb
!
!
interface Ethernet0
ip address 168.215.178.2 255.255.248.0
no ip directed-broadcast
no ip mroute-cache
no cdp enable
!
interface Serial0
no ip address
no ip directed-broadcast
no ip mroute-cache
no fair-queue
no cdp enable
!
interface Serial1
no ip address
no ip directed-broadcast
no ip mroute-cache
no fair-queue
no cdp enable
!
interface Group-Async1
ip unnumbered Ethernet0
no ip directed-broadcast
encapsulation ppp
async mode interactive
peer default ip address pool DialPool1
ppp authentication pap
group-range 1 48
!
interface Dialer1
ip unnumbered Ethernet0
no ip directed-broadcast
encapsulation ppp
dialer in-band
dialer idle-timeout 99999
dialer-group 1
peer default ip address pool DialPool1
no cdp enable
ppp authentication pap
ppp multilink
!
ip local pool DialPool1 168.215.178.206 168.215.178.254
ip default-gateway 168.215.183.254
ip classless
ip route 0.0.0.0 0.0.0.0 168.215.183.254
!
snmp-server community (*****removed*****) RW
snmp-server community (*****removed*****) RO
radius-server host (*****removed*****)
radius-server host (*****removed*****)
radius-server key (*****removed*****)
!
line con 0
exec-timeout 0 0
transport input none
Line 1 48
autoselect ppp
modem Dialin
transport input all
speed 300
Line aux 0
Line vty 0 4
password (*****removed*****)
!
end
02-20-2003 09:06 AM
Did you try with any other make of Modem banks.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide