AS5300 Outgoing E1 configuration

[shefiksah]

Hi,

I've got a voip setup using an AS5300 and a VM (Voice Master) gatekeeper/radius server.

The AS5300 has 2 E1 lines, one incomming and one outgoing. Also it as a IP line for Internet access.

VM <-> AS5300 <-> PSTN, Internet

AS5300:

E1-> to PSTN

<- E1 to PSTN

<-> IP to Internet

Problem is I can dial from the PSTN into the incomming E1 and access the IP network (IP phones etc).

But I cannot make calls out the outgoing E1 to the PSTN.

- The VM is sending the call to AS5300 and the PSTN outgoing E1 line is provisioned to allow calls to the PSTN.

Any chance to check the config if it is set up properly and maybe how I can make calls ?

Thansk alot,

Regards

Shefik

[luizcs · Accepted solution]

Hi Shefik;

Try to program a dial-peer just to termination, like this:

dial-peer voice xxx pots

destination-pattern .T

port x:d

forward-digits all

VM can handle prefix , using gateway termination map (ex: xxx=yyy;). Be aware about gatekeeper routing on VM, your termination gw have to be present on the route that you chose.

I hope it can help you.

Luiz

[shefiksah]

Hi Luiz,

I just had a chance to try this now and guess what, it worked. Calls are going through.

I thank you very much for your kind assistance.

Best Regards

Shef