11-04-2009 01:18 PM - edited 03-13-2019 06:44 PM
Any idea why I cannot ping the AIM-CUE ?
thanks
interface Service-Engine0/0
ip address 10.224.32.17 255.255.255.252
service-module ip address 10.224.32.18 255.255.255.252
service-module ip default-gateway 10.224.32.17
!
#ping 10.224.32.18
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.224.32.18, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5)
11-04-2009 01:33 PM
Check that module is running, via service-module session.
11-04-2009 10:46 PM
I can make session to module, and also it says up when I check it.
11-05-2009 02:06 AM
When is session, check with the show commands, thta the addresses are right.
11-05-2009 02:33 AM
Hi,
Check to have an ip route to the service module ip address with subnet /32 and output interface service engine
thanks & best Regards
Hytham Hadad
11-05-2009 02:37 AM
That should not be necessary, because a dedicated subnet is being used, not unnumbered.
However, I agree that unnumbered using a voice VLAN address is a better choice.
11-05-2009 03:19 AM
I reloaded the module and it is ok now :) interesting...
11-05-2009 03:35 AM
Why you should ?
Either use explicit or unnmbered, as recommended by configuration guides.
11-07-2009 10:29 AM
Hi Paolo
thanks for our note
11-07-2009 10:49 AM
You are welcome, please remember to rate useful posts with the scrollbox below.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide