09-07-2017 07:29 AM - edited 03-13-2019 10:01 PM
Hello,
Can anyone verify that the 3640 does NOT support network-clock commands? If not, how do you configure clocking for a PRI?
Thanks,
vp
Solved! Go to Solution.
09-12-2017 11:29 PM
Hi,
Any routers with a TDM clock on the motherboard require the 'network-clock-participate' and/or 'network-clock-select' commands.
With the 3640, this does not have a TDM clock on the motherboard so these commands were not necessary.
This is pretty much what i understand about 3640 and hence shared with you.
Manish
- Do rate useful posts -
09-12-2017 11:29 PM
Hi,
Any routers with a TDM clock on the motherboard require the 'network-clock-participate' and/or 'network-clock-select' commands.
With the 3640, this does not have a TDM clock on the motherboard so these commands were not necessary.
This is pretty much what i understand about 3640 and hence shared with you.
Manish
- Do rate useful posts -
09-13-2017 06:33 AM
Thank you Manish. I was trying to setup a 3640 for dialin access over a PRI and was getting error message "modem not found due to wrong b chan num..." as documented in bug CSCsc43419. I saw a thread about using the network-clock commands to resolve. I was able to get it working by making a number of other config changes.
Thanks for your response.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide