09-06-2012 07:52 AM - edited 03-13-2019 07:57 PM
I have CUCM 8.6 at HQ and 5 branches ,I'd like to use G711 inside the HQ(Lan) and G729 between the HQ and the branches .
Any support will be appreciated
Solved! Go to Solution.
09-06-2012 08:24 AM
09-06-2012 08:25 AM
e.g
ephone 1
codec g729
Please rate all useful posts
"'Nature is too thin a screen, the glory of the omnipresent God bursts through it everywhere"-Ralph Waldo Emerson
09-06-2012 07:57 AM
Sorry I got mistake I mean CUCME not CUCM
09-06-2012 08:03 AM
In CCME, you cazn configure your phone to use whatever codec you prefer. So in this case configure the phones at your branch to use G729 codec. Its simple
Please rate all useful posts
"'Nature is too thin a screen, the glory of the omnipresent God bursts through it everywhere"-Ralph Waldo Emerson
09-06-2012 08:12 AM
Question is how do you make them use G729 between sites and G711 within site? I am not aware of doing this in CME as you surely can hard code the codec on ephone but you cannot defined multiple codecs like Regions in CUCM, If the remote locations had their own CME then you simply control it with dial peers.
HTH,
Chris
09-06-2012 08:18 AM
thanks for your reply but from where I can change the Codec on the phone
09-06-2012 08:24 AM
Under ephone.
Chris
09-06-2012 08:25 AM
e.g
ephone 1
codec g729
Please rate all useful posts
"'Nature is too thin a screen, the glory of the omnipresent God bursts through it everywhere"-Ralph Waldo Emerson
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide