dsp module and ISM-SRE-300-k9

[c.rodriguezesteban]

Hi

i have a couple of questions regarding this,

when i had installed the pvdm3-64 module on an 2921 running a cme , do i need to configure anything else or the resources are already aviable?

And could anyone post a link for the phisycal instalation guide od the ism-sre-300-k9 on a 2921, because im no been able of findinf it.

thankn in advance

Cesar

[paolo bevilacqua]

q1: no

q2: 2921 hardware installation guide, "installing internal modules".

[c.rodriguezesteban]

actually the installation went ok, but im unable to ping the service module

interface ism 0/0

ip address 10.0.0.1 255.255.255.0

service-module ip address 10.0.0.2 255.255.255.0

service-module default gateway 10.0.0.1

anything wrong in here?, actually its traight from the configuration guide

regards

Cesar

[paolo bevilacqua · Accepted solution]

Same as ny other CUE

Make ip addres unnumbered from the voice vlan interface.

service-module use an address from same subnet.

static route /32 pointing to ism0/0

That is also in the guide.