Hi All,
May I know how to break the dial tone when pressing any keys? I've tried to set the input gain to 0 dB, -1dB, -4dB and 4dB but same results.
Voice-port also configured in "timeouts interdigit 3". In other sites, same configured but it is working.
Is it defective or need to be configured?
Highly appreciated for your response.
Thank you
Regards,
RJ
Start mentioning equipment type, configurating, wiring to used to phone.
Thanks for the reply Paolo.
VIC3-2FXS/DID, and RJ-11 for phone.
config:
voice-port 0/1/0
timeouts interdigit 3
I also tried to add input gain like I said on my post. But its not works.
Thanks and Best regards,
RJ
Which protocol do you use to call control? Have you tried another phone ?
Sorry for the late reply.
I have encountered error: PVDM is not working properly.
The issue was resolved after cleaning the router.
Thank you
Regards,
RJ