11-27-2012 10:42 PM - edited 03-13-2019 08:04 PM
Hi All,
May I know how to break the dial tone when pressing any keys? I've tried to set the input gain to 0 dB, -1dB, -4dB and 4dB but same results.
Voice-port also configured in "timeouts interdigit 3". In other sites, same configured but it is working.
Is it defective or need to be configured?
Highly appreciated for your response.
Thank you
Regards,
RJ
11-28-2012 04:21 AM
Start mentioning equipment type, configurating, wiring to used to phone.
11-28-2012 03:35 PM
Thanks for the reply Paolo.
VIC3-2FXS/DID, and RJ-11 for phone.
config:
voice-port 0/1/0
timeouts interdigit 3
I also tried to add input gain like I said on my post. But its not works.
Thanks and Best regards,
RJ
11-29-2012 04:26 AM
Which protocol do you use to call control? Have you tried another phone ?
12-12-2012 06:18 PM
Sorry for the late reply.
I have encountered error: PVDM is not working properly.
The issue was resolved after cleaning the router.
Thank you
Regards,
RJ
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide