No ring-back tone

[paolo.pennisi]

Hi,

I have a problem with a 2600 that doesn't give ring-back tone when I make a call from an Ip Phone to outside through the ISDN port. Ios version on this router is 12.2.(4).

I have already tried to configure on the dial-peer # pots that go outside the commands:

progress_ind alert enable 8

progress_ind setup enable 3

as indicated on the troubleshooting for this problem, but these doesn't solve the problem.

I have made the same configuration on another 2600 with Ios 12.2(1) and this works. Could be the Ios the problem for the ring-back tone?

[marinaibm]

Hi,

I'm not sure about IOS, but it could be just a routing problem. Try to add ip route 0.0.0.0 0.0.0.0 eth0/0 .Hope it helps.

Marina

[msolak]

Hi,

try it again with:

"voice call send-alert " global command.

This sends an alert message instead of progress.

Good Luck

[paolo.pennisi]

I've already configured 'voice call send-alert', but it still doesn't work.

Thanks