Can not delete the ip igmp join-group command on NX2Ks.

[Sergio Gaytan]

Hi,

I have 1 NX5K & 1 NX2K (FEX) and configured PIM on them -Release 5.2(1)N1(1).

I configured on the NX2K's ports the ip igmp join-group command to statically bind a multicast group to an interface. The multicast PIM works fine but when I try to remove the ip igmp join-group command on any interface because not all should have this command, I cannot.

I have not found any  bug on the 5.2(1)N1(1) version related to this behavior and the released notes not mentioned anything about this.

Any ideas...!?

-Sergio

[Prashanth Krishnappa]

Hello Sergio

FEX ports are meant to be L2 ports only and hence you should not be allowed to configure "ip igmp join-group" but looks like we do allow it which is a bug.. I will see if there is one filed for it and if not file a new one.

Thanks

-Prashanth

[Prashanth Krishnappa]

Hello Sergio

I have filed a new bug CSCuc58233 for this

Thanks

-Prashanth

[Sergio Gaytan]

Prashanth,

I have attached the file where you can see that I said (interface Ethernet101/1/1) and I would like to know when I can see the bug details.

Regards,

-Sergio

[Prashanth Krishnappa]

Hi Sergio

New bugs take 48-72 hours to be visible on Cisco.com

Thanks

-Prashanth

[Sergio Gaytan]

Hi,

Do you know when the information about bug ID CSCuc58233 will be available.

Regards.

~Sergio