The switch is WS-C2916M-XL . The switch gives the following message when the copy run star is executed.cat2916# copy run startNon-Volatile memory is in useNon-Volatile memory is in use[Failed]cat2916#Is any anyone aware of any known issues.
Hello ,Is it possible to set up a PVC in a back to back ATM topology using the modulesNM-1A-E3 ( these are one port ATM E3 modules for CISCO 3600 routers )Thank you vladimir
Can I create a PPP multilink bundle between frame-relay and ATM interfaces? I have a spoke site connecting to the HQ using three frame-relay T1s. Those T1s connect to three sub-interfaces on an OC3 ATM interface. The cloud provides FRF.8 translati...
I have recently started my CISCO education and have obtained 2 2500 series routers. This may seem like a simple question,but I have to ask it. I am trying to configure nat on a 2514 router running IOS 12.2. My ISP has assigned me a static IP of 68.10...
--begin ciscomoderator note-- The following post has been edited to remove potentially confidential information. The configuration was removed, edited and posted as a new message by ciscomoderator due to newly implimented posting size restrictions. ...
Using network monitor and/or sniffer is impossible these days because of the popularity of switches. I usually carry a small hub with me so that I can connect routers and other devices to the same collision domain as my sniffer. What is going to ha...
We set up XOT via an IP network to reach a public host. The last part of the connection is via an x25 serial connection. that's working fine. There's only 1 "problem" left.If during the Call the XOT session is lost due to TCP is lost , the Call w...
Dear all,in RME I have problems with the configuration archive. About 75 % of the attempts to get the running and startup config are failing (but always with changing devices). The message I get is "Failed to get the beginning of the configuration fi...
If i putip route 66.32.32.32 255.255.255.255 192.168.0.1all traffic to this host is routed properly, but any other external host with an IP that begins with 66.xx.xx.xx is now not reachable. There are existing routes for specific hosts and network...
I'm trying to Nat a few machines in a remote location, attached by a point to point T1. I cannot ping the through the NAT though attached is my config, even though all of the other connectivity is intact. The other end of the serial link is 172.20....
Hi,I'm having a strange behaviour when the number of L2TP sessions increase on a 7200 VXR LNS. STM1 carrying multiple PVCMultiple LACs (MAXTNT, CVX) --------------------------------------->7200 VX...
The DS1 to our ISP is saturated, and we don't want a 3MB segment on a DS3 ($$$) Can you point me to the proper white-paper, describing how to set up load-balancing across two DS1s, in a PPP-group, to achieve ~3Mbit aggregate?alex.batson@honeywell-ts...
Hi...My PC is running on Windows 2000. Sometimes my PC hangs or frezees for a while (about 5 seconds). This problem started to happen after I move my network connection from a hub to a Cisco Catalyst (3500 series).If I connect it back to the old hu...
I have a 3725 router with 3 seperate atm interfaces connecting to 3 seperate ADSL lines all supplied by the same ISP each ADSL line has a static IP address and all the lines are on the same PVC. I want to use one line for internet access and the othe...
