Other Network Architecture Subjects

Hello, I am having a problem associating an AIR-LAP1142-E-K9 AP to our WLC4402 Controller (running version 7.0.230).I have connected a console cable to the device and when it boots up it picks up an IP address. I have then entered the controller IP u...

Hello Allwhich will be an ideal model of router to support VPN connectivity to 35 branch officeBandwidth 10MBGRE over IPSEC2 Internet Provider Connection which will be ideal model of access switch to supportQOS40 users connectivityPOEthanks

A "sh ip bgp sum" gives a session in a "PfxCt" state. The session does not come up but stays in this state. What does this mean?

Hi          provided that it is necessary CME 8 users, 4 FXO, 4-8 FE Poe2901Voice + Wic2-4FXO + Hwic-4FE Poe + Poe power suply?

AAA on Cisco DevicesIOS ACLsAre the IOS commands the same on a router and a ASA for these two topics....CBT Nuggets where I train has 553 videos for some of the new topics. I am preparing for 554 as it has more ASA focus and thats more interesting to...

Hello everyone, I am reading the Cisco 5.2.3 ACL WIldcard Masking chapter and I have come across a stump....something that I cannot get myself to understand.With the image that I've attached, you will see that cisco is using the 192.168.10.0 IP and a...

Hi,I have to configure a firewall in China.  I am in US and want to be able to configure the firewall in English but will have to purchase when in China.  Can I purchase an English language firewall and have it supported by CIso in China?  Or do Ihav...

Hi All,I have been assigned a task to deploy an additional ASA firewall to a existing customer network.Current infra1x Cisco ASA that is used for internet traffic and MS_Exchange Mail trafficProposed new infraAdditional Cisco ASAUsed for Remote acces...

I have a situation where My 6513 chassis is covered by smartnet as are most of my line cards but my Supervisors - SUP2 is End of life - end of support - What will happen if i need config help - or a hardware issue with the supervisor ? anyone run int...

Hi,I am wondering since 2010 has the CCNA exam changed for a 2012 versoin? or does it still use the exact same questions from then.The reason being my friend and I are trying to find more information about it, because he passed it in 2010 and will ne...

Dears,I have a cisco 2821 router configured as a CME version 7.1.Now I want to upgrade the IOS to version 15 to get a CME version 8.6 but I faced a problem that the flash of the 2821 is 64MB and the IOS version 15 required flash 128MB.I tried to repl...

Hi all. A bit of newbie question this, but I can't get the answer straight in my head!If I had a subnetted network as below, would I get say in subnets #127 & 128 the IP's marked with the arrows as valid host IP's to use?     10.1.3.65/23255.255.254....