We configure the dlsw with high priority, and low for http protocol. At the remote site, we download a file by web browser and try to start NetBIOS session from a workstation. But NetBIOS session could not be established. When we stop the download, t...
I Have two gateways to the internet, on separated routers.These Routers are connected to a FR Cloud, and one of them is the point to multipoint hub of the cloud.THere is only one subnet along the cloud.The access routers in the cloud have the default...
What should I change in the configuration in order to limit all dialin calls in the AS5300 to V.34? My current configuration allow connection up to V.90 but I need to limit it to lower speeds.
We are using MLP to bond two T1 lines and are running IP, IPX, and Appletalk over it. IP and IPX work fine and the Appletalk routes appear in the routing table. Appletalk pings between the routers work, but pings to workstations across the MLP link...
How can I generate a load statistic report of an dialer interface with ppp multilink bound to a E1. The customer wants to generate a long time statistic of that dialer to detect the load of the connection.
I've got a point to point DS-3 between two locations. My carrier is not providing clocking on this circuit. Should I configure one side of the circuit to "Internal" clocking and the other side to "Line" clocking?
I need to connect 24 analog phones to this module.1)What cable do I need to connect these to the RJ-21 connector ?Is this a category 3 RJ-21 telco cables with the following colour standard :pair 1 : white/bluepair 2 : white/orange....2) can we order ...
For some reason my Dial-up line keeps disconnecting. I am using a 1602R router that dials into my isp via a modem and a Serial asyc line. I would like the line to stay up as long as there is traffic ever 15sec.show runnBuilding configuration...Curr...
I have many Cisco switches and routers in my network, I am looking for help with SNMP v1 issues. Is there a listing of versions of software IOS to move to to avoid attack problems.
i can't understand from UniverCD about subject, because in the PPTP FAQ "VPN as PPTP server only", but the Feature Navigator has nothing about subject.Q: Can any IOS support VPN as PPTP client mode on Cisco 1601R? (initiate VPN connect?)
Can I assign a user privileges to run a set of commands that only users with higher level can run?For example, I'd like to give a user with level 0 the possibility to run some dsp... StrataCom commands.
I see references to "nodes" and I'm not sure if nodes are considered routers/switches/hubs or just routers or all devices on a network. This is not clear to me.
