Dear community Can anyone help me to understand the QoS command "show policy-map interface in ios XE? In each queue i can see 7 classes and justo some of them have packets, do you know how is the traffic balance in this classes or how to interprete ...
a bit confused, so what version of IOS am I running? I see 16.12.04 and 16.12.4. i see the name of the ios as cat9k_iosxe. thanks. show verCisco IOS XE Software, Version 16.12.04Cisco IOS Software [Gibraltar], Catalyst L3 Switch Software (CAT9K_IO...
Good evening, I'm trying to configure a 4351 to be a DNS server for some appliances and for some reason the "ip dns server" command doesn't come up: (config)#ip ?Global IP configuration subcommands:access-list Named access-listaddress-pool Spe...
I have two questions.<Event> It works VRRP between two ASR920's. -One of ASR920's sends the following syslog, %VRRP-4-WARN : Internal warning, Remote address is same as our address -Process= "VRRP Main thread, ipl= 0, pid= 164" -Other ASR920 don't ...
We're looking into a three-switch solution. 9300L series, all three. We're wanting to run this in a stack with one being a Layer 3 device and the other two standard Layer 2 switches. Need to know if it's possible to run all three in one stack or i...
Is your company equipped to empower hybrid work experiences at home, in the office, or anywhere? This new era of work requires a new approach, one that enables you to safely welcome workers back into their workplaces, while enabling flexible operati...
So I'm going to have an interview for Network Engineer soon. I always get kind of nervous because I usually get questions to prove my knowledge. Now, because of my previous jobs I have far more experience with WAN than with LAN almost nothing with fi...
I need to do to swap out my N2K-C2248TP-E with N9K-C93180YC-FX3. All my searching has turned up nothing regarding a procedure to achieve this. Regards Fabian
we want to do a renewal support of virtual cisco prime 3.4. but the serial number that appears on the UDI is not readable on the CCW-R. did we make a mistake in looking for the serial number to be renewed? or what do we need for the renewal of Virtu...
Hello, In my network connection tools, I can't find cable splitter but can find coaxial splitter. I would like to know if they are the same, if no, then kindly guide m
Hello, In my packet tracer, after connecting the coaxial cable splitter (coaxial2) to the TV using the TV cable, once I turn on the TV, there's a green arrow signal and when I turn it off, it shows a red arrow signal. According to Packet tracer, if...
I am trying to configure a NTP IP address to be configured as a systems peer. not sure what the command is for this or the steps to getting it to populate as a systems peer under my NTP peer associations list.
I would like to see terminal logging output during an SSH session the same I would see when I am consoled into the device. What I mean by terminal logging is output to the terminal screen when events happen (OSPF neighbors connect, a port is disconne...
We are planning to migrate the nexus switch 7004 to nexus 9300 switches . We have three vdc (one admin , one layer 2 core and one layer3 ) . I am doing ist time datacenter core migration . What all precaution we have to take ? what will be the ma...
Hi Guys,I am practising the subnetting topic and Need a assistance in Usable host part.Below is the scenario:-My requirement is for 510 hosts.IP address:-192.168.1.0/23My subnet mask is -255.255.254.0i/p range-192.168.1.1-192.168.1.255192.168.2.1-192...
