Hello everyone, Hope i get some solutions and options here, We have two data centers located in NY and in LV. we are planning a DR plan where if one DC goes down in a disaster event, second DC can take all the traffic. On NY side, we have ASA firewal...
Hi Guys,Can anyone tell me why PT wants a crossover cable to connect the router to PC2 in the attached scenario? I understood crossover cables connected like devices, not different ones. I have verified that this connection does not work with a strai...
Hello Guys, I wanted to know where i can get more information on technologies such as Reporting and Dashboard. I know about monitoring network traffic and we have many software/tools for it. I have an interview where they are looking for below skill...
I need 9200 L2 and 9300 L3 series switches all with 10Gbps uplink ports as shown in the diagram.Please let me know if its possible as per the attached diagram,all uplinks from 9200 to 9300 L3 switch should be 10Gbps.Also let me know the maximum poss...
Dear AllI have a question about licenses Access point of Cisco Prime.If I have licenses APs just 100 Licenses But I have APs about 200 APsSo Licenses on Cisco prime not much so i would like to know what effect about 100 APs it not have licenses than...
Hello, For the models listed in the title, when I check the datasheets, I get maximum power data but no mention of idle or standby power.Where can I get these data? For example, for ISR 4551 the datasheet mentions:Typical power (no modules) (watts)15...
Hello, I need to update the value of the 'shape average x' command which is currently live on an interface via a policy-map / service-policy command.If I change it to the updated speed, will this have any adverse affect on traffic ?Thank you kindly. ...
i,I'm hoping for a bit of advise.I have been tasked to reconfigure 2 switches( 2x2960) and 1 router (ASR1001) that are currently connected with a ROAS config with only one trunk between the ASR and SW1 and another trunk between SW1 and SW2. Each SW h...
Why OSPF use wildcard mask? Not subnet mask? Any advantage of using wildcard in OSPF? How wildcard in OSPF work? I saw some OSPF configuration for class b network use 0.0.0.255 as an OSPF wildcard mask. What does it mean? Is that mean to exchange onl...
I'm trying to set up our core Nexus 9000 to be an NTP server for our other network devices. The Nexus is pulling time info from the Internet without a problem, but I cannot get other internal devices to connect to the Nexus to sync with it. It just...
I have two 3945 ISRs which are hubs in a DMVPN network. They learn the routes of dozens of sites connected over the DMVPN. A redistribution is used take the routes from the AS 201 of the DMVPN to the AS (10) of the HUB to ASA connection. HUB1 redistr...
I have been trying to find an answer to my question. If we have Cisco DNA 3 Node Cluster, can we divide the roles among them for example based on NDP and NCP?Can they share the load of requests coming in when in HA mode or will only one server respon...
