cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
330
Views
10
Helpful
2
Replies

Packet loss showing strange result

I need some help me figure out why ping drops but I still get 0% packet loss:

> ping rapid count 1000 size 1400
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
1000 packets transmitted, 997 packets received, 0% packet loss
round-trip min/avg/max/stddev = 0.480/1.818/15.843/1.369 ms

Thanks in advance.

1 Accepted Solution

Accepted Solutions

Bryson F
Beginner
Beginner

3 drops out of 1000 is also not enough to round up to 1% if my quick math is correct. i think its only a .3% packet loss i would not label that as an issue per say either.

View solution in original post

2 Replies 2

balaji.bandi
VIP Community Legend VIP Community Legend
VIP Community Legend

what device is this  ? what IOS Code running ?

where is the destination IP (what device is that)  what is the source IP ?

is this only for 1 device and IP all over network?

can you show us the routing table and traceroute to the destination?

Also, provide  below information where possible :

show run

show interface x/x (where the outgoing interface )

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Bryson F
Beginner
Beginner

3 drops out of 1000 is also not enough to round up to 1% if my quick math is correct. i think its only a .3% packet loss i would not label that as an issue per say either.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers