Router try to load old IOS after an upgrade

kabdulla · ‎03-16-2002

After upgrading flash memory and IOS on a 4700 M router, the router didn't load the new IOS. It is tring to load the old one which was deleted at the time of upgrade. Now I can only boot with bootflash. Please let me know how to set the correct path to new image to load. There are two partition in the flash. Partition 1 has the new IOS, partition 2 is empty.

zujun.fan · ‎03-16-2002

you could use a command to make the two partition into One!

Erick Bergquist · ‎03-17-2002

Did you have a 'boot system ...' command in the config with the old IOS filename? If so, you need to remove that from the cfg.

glen.grant · ‎03-21-2002

Get rid of the old boot system command and put in the new one pointing to the new IOS image and make sure to do a write mem otherwise it will just continue to try and load your old config .

kabdulla · ‎03-22-2002

Thank you all. It worked.

vijayendra_sharma · ‎03-22-2002

Hi Ka,

Where did you goofed Up ??

regards,

Vijayendra.

mberrocal · ‎03-24-2002

oops, problem already solved...