Hi,I have to backup a system, where Sensors an Blades are working. I want to know, if one of my Blades fails, can i migrate the configuration to a bakup Network Sensor? I guess, it's not a problem, but I want to be sure!Thanks!
I have IOS 12.13T and tried also with 12.15T, Cisco 1710.If I issue a debug ip packets, I do only see the outgoing packets, not the incoming ones. Any idesSorry, not really a security related issue, but I did't find where else to put this question.th...
Is the beta available for download anywhere. I know I will need the smartnet for the full release. Again I am still under the assumption that 6.3 is still in beta. Thanks.
Has anyone had a problem with the recent change in Mircosoft not installing its VM with the IE, you have to go get Sun Java. The VM worked fine with the PDM the Sun Java doesn't work. Anyone know if a upgrade in Pix firewall addresses this issue?I...
Here is my config on supervisor II on 4006 switch Console> (enable) show spanDestination : Port 4/10Admin Source : VLAN 2Oper Source : Port 2/3,2/5-6Direction : transmit/receiveIncoming Packets: enabledLearning : enabledFilter...
Hi,I am facing problem with pcanywhere connection through my PIX firewall.I have an access-list which says : access-list permit ip any anythe pcanywhere works fine with this.now In place of "permit IP any any" , i want to allow ports 5631 and 5632 ...
Hi,has someone a running configuration for the following scenario:- Cisco 826 as EZVPN Client (fixed IP Address on Ethernet 0, IP Address negotiated on dialer 1)- PIX 515 as EZVPN ServerThanks in advanceEdgar
I have several custmomers that are considering Fatpipe's Superstream and would like to sell Cisco product instead. Has anyone duplicated the functionality in Cisco gear? Basically,its aggregating bandwidth from two small Internet pipes. I.E. DSL, Ca...
I have 2 routers and 2 pix firewalls which are connected point-to-point via frame-relay..On each of this networks, reside an NT Domain configured as trusted (through trust relationship)...This will enable me to brouse the other network and vise vers...
I have site to site connection as fallows;3005_A---> internet ---->3005_B----> internet ---->3005_C --->3005_DI can connect and ping from site 3005_A to 3005_B and from 3005_B to 3005_C , but can’t connect directally from A to C or from A to DDoes I ...
