Other Security Subjects

Hi,I ask if sameone knows where a can get information or if this is not the way a think.I have a PIX-525 and two server linux. This server linux have there own ip addres and there own mac address, they are instaled in a failover squeme. So one (the a...

Hi everybody,I've a problem with Checkpoint logs with MARS. I've add Checkpoint SmartCenter(successful discovery, LEA, CPIM) to MARS. I've tested successfull connectivity. But I do no log is pulled from Checkpoint firewall. Can somebody help me, plz....

Cisco press book Security Monitoring with Cisco Security Mars on page 68 sais that for MARS-110 appliance from total 1500GB, only 866GB is available for storage. Additionally same information can be found (although language is Hungarian, this part is...

I am getting the following error on my MARS box, any assistance would be greatly appreciated."Program aborted due to: ORA-01033: ORACLE initialization or shutdown in progress".I have see a couple of Oracle-specific posts that suggest that it may be r...

Hi all please anybody tell me how to configure switch and ACS for mac address based 802.1x authentication

Does anyone know if the CAM would move connected hosts out of the certified device list and thus into the Authentication VLAN if the hosts are close to being expired on the CDL? Or are the connected hosts kept on the access vlan when they are close ...

Hi,Can anyone offer me advice on configuring CoPP on internet-facing edge routers?I'm running 12.4(21a) on 7200VXR's.I have an initial configuration with the usual well documented classifications (http://www.cisco.com/web/about/security/intelligence/...

I'm trying to add a MARS to a fresh install of CSM 3.2.0 through the CSM client. I constantly get the message:Connection with CS-MARS failed. Incorrect username or password. Make sure the CS-MARS username and password are valid. I'm sure that the cre...

how do I change the ip on the csc module through the command line. I am not able to get into through the web brouser anymore after changing office ip network.

Help me please to solve the problem.I had installed Management Center for Cisco Security Agent v.6.0. However I can't generate Agent kit.The status of all Agent kit is "Needs rule generation". I try to generate rules but there is an error - Failed to...

Hi,I have a a setup with one CAM, one CAS and a firewall between them. There is also NAT in place.I changed the requiered things like in the configuration guide. After the changes, I'm able to connect the CAM with the CAS. But after the a reboot of t...

I tried to add live IPS device (6.1(1)E2S364) to CSM (3.2.0 and also 3.2.1 sp1)from network. This device has CET timezone configured. Everything went Ok while importing but when I tried to deploy some changes to this device, CSM cleared timezone conf...