I am working with our Infosec team. They need syslog for a SIEM and are requesting the use of port 300xx. This is an old 3560G core switch (Yes, it needs to be replaced) and it would not let me add a port to the logging host command. Commands used...
Please let me know what is IP source Route and why is it disable for security purpose.Thanks in advance
Hello all, I have trying to get Ransim simulator for knowbe4 blocked by firepower and I cannot seem to get to block anything but one scenario, end point security catches 100%. Without endpoint security everything is vulnerable. I have a malware rule...
Hi all,im now using webex teams fanatically. Now i'm asking myself is my data accesible after let's say leaving my company? Or do i have keep a personal copy stored somewhere of stick to other programs for my personal data.
Hello.Im looking for specific information regarding performance numbers for ISA 3000, Im talking about NGFW throughput with IMIX packet size for example. In adition, could you please corroborate if the power supply PWR-IE50W-AC= actually support IEC ...
May I know which ports should I allow for my access list to allow my group policy objects to pass through my core switch which is a layer 3 switch. Here's a sample of the ports I used permit udp any eq bootpc any eq bootpspermit icmp 10.10.20.0 0.0.0...
Hi Guys, does someone of you know how to hide the rip authentication key in the config file when doing a backup with RANCID of an ASA Device? We backup all Network Devices with Rancid V3.12.By default, stuff like IKEv1 and IKEv2 pre-shared key are re...
We have Cisco Firepower Management Center 4000 hardware appliances.They are running the current Cisco recommended version of Firepower software i.e. 6.4.0.9These FMC 4000 hardware appliances are based on Cisco UCS C220 M3 rack servers, and each conta...
Hi Team, I cannot config or update policy with FMC (FTD FPR4100). When i update policy and want to save and deploy, this error show " deployment failed due to connectivity issues with the device or device is not responding. if problem persists after ...
I am trying to change the security context on an ASA 5515 from 2 to 5 security context
Hello everyone, i do not understand why there are two SA in the output, when i configure ipsec in mode tunnel appear only one SA but when i configure ipsec in mode transport appear two SA, i am not really sure if i did a mistake or if the reason is a...
when i set command "lifetime ca-certificate 7000",the check command show error like this to me how can i set my ios CA's expiration date 20 years?
Hi Everyone,So I have a scenario where we gave an FTD-1010 appliance Management Interface a Public IP address. Can anyone share experience about the content of the ACL written to protect it from unwanted connections?Thanks.Jim Goughenour
Hello, I got a reported alarm from the customer, so it looks like if phase 2 VPN (IPsec) has some issue, however when I validate the status of the IPsec it is active. Alarm:Último interno Alias de nodo ...
I have a pair of 3850's, between them is a 5 member Etherchannel, on each Port there is a Pair of Microwave Radios, 10 in all, that have specific IP addresses for management, in a specific in band management Vlan100, it is not native and not Vlan 1, ...
