Other Security Subjects

Hi,I have a quick question for pix. Does pix use stateful table for connections initiated from outside (lower security) to inside (higher security)?Who could explain this to me? I am confused about how pix deals with connction initiated from outsid...

My Internet connection went down yesterday. On my pix log, I notice I have a lot of ping from my ISP's router:%PIX-4-106023: Deny icmp src outside:123.456.789.1 dst inside:192.168.1.1 (type 3, code 1) by access-group "outside_access_in" Typically if ...

I am wondering if it is possible to track IP addresses of computers on the Internet that make requests to a Web Server in the DMZ behind a PIX 515. When looking at the communication to the Web server, the request comes in as originating from the DMZ ...

I'm trying to track down strange CPU spikes as traffic increase. Right now, Fa0/1 is doing 5mbit in/5mbit out, and CPU is at 45 percent. I'm not running anything special (just snmp, no web, 1 static route to switch traffic to a gateway)Fa0/1 is our u...

FWSM problems with OSPF and VLANsWe are trying to configure OSPF on our new Firewall Services Modules(running 2.3(1)) on a Cat6k's. The FWSM are configured for single context routed mode, allowing it to route between VLANs.Each VLAN has been defined ...

Taking control of local network after splitting from home office. The no fixup protocol http 80 in config of PIX. Anyone guess as to why? Not running H2H2. Just curious.

Hello!We are planing to use two new CISCO3845 with firewall feature set to replace Pix525.Is there a way to keep the configurations (or part of it like acls) synchron in a similar way to the pix automatic replication?

Trying to figure out the command to enter to have the PIX reload at a given time.

Hi all,I have following problem with NAT/PAT on my PIX 515:all incomming traffic from outside to dmz_host to be hide on DMZ interface (no outside sources are to be visible) - and this is the statement:global (DMZ) 1 interfacenat (outside) 1 0.0.0.0 0...

Hi,Can someone tell me if CSA can help in the followingI need to provide remote access to a third party untrusted company to a system they manage via VPN.It consists of two Unix servers and two Windows servers and runs a web based app which will be a...

Hello,I'd like to create a new user for ssh access on a pix501. which commands should I use?thanks,travis.

Hello, Simple question realy.Could anyone tell me what the SAFE in SAFE Methodology actually stands for. I have recently heard different interpretations.Thanks

I'm a relative newbie and am curious as to what the thoughts are around the PDM. I have previously setup a 506e (basic) using CLI and the startup wizard. I just setup the basics on my 515e using the PDM and the quickstart guide. A couple questions...

We would like to retain fw logs for forensyc and audit use. Any good solutions for a syslog server with some decent archiving/compressing of logs and search functionality?

Hi,Whitch version of SNMP is used by default in the PIX 535 running with software 6.3.4?Is it the version 3?