Other Security Subjects

Hi all,There doesn't seem to be a Firewall IOS for the Cat4500 (is this right?), nor a firewall blade like you can get for the Cat6500.Suppose I've got a Cat4506+SupIV/V doing inter-VLAN routing for about a dozen VLANs, all of which require firewalli...

hiit was not very clearly in the documentation that you it sent, I continue in the doubt, I go to explain the environment, example, I have a roteador 7206 vxr with the interface atm1/0.177 172.16.194.157, will be that acl is possible to implement one...

The certificate on our VMS server has expired. I created a new using the "gencert" program, but when I try and push a sig update to the sensor, it still picks up the old certificate. I need to delete that one but there is no doc on it.Thanks,Peter

I am having an issue configuring my firewall to allow inbound traffic, for everyone on port 80 or 443. This is the first time I am setting up the pix506e , this is my config, can anyone helpPIX Version 6.3(3)interface ethernet0 autointerface ethernet...

Hey all,We have been using a pix 515e with just the inside and outside interfaces for a little while now. I want to venture into setting some of our public servers in the DMZ. I want to get a better understanding of what I will need to do.Here is wha...

Hi,does anybody know if it is possible to configure PIX 501 running as Easy VPN Client in network extension mode to relay DHCP requests to a central DHCP server which can be reached via the VPN tunnel ?I didn't manage to get this up and running, but ...

first I have one ids 4215, managed for the Cisco works,route 7206 vxr with 345 subinterface ATM, as I make to create in ids, when to recognize an attack to create one acl automatic specifies for one subinterface atm

Management Center For Cisco Security Agents v4.0-1 build 544Open management center for CSA --> Monitor --> Event LogOne of the log entries is similar to this (note IP goes where xxx is):44 16/04/2004 1:06:50 PM host700 Alert TESTMODE: The process 'C:...

Hi,I would like to get recorded the information "Who is getting logged into the router via telnet ?"by using the function router has itself that is justusing "username" and "aaa authentication ... local"commands, not using TACACS + or RADIUS.I under...

Has anyone come across this message?"Startting cidewebserver...Error: Sensor not initialized. Login as root and run sysconfig-sensor.The system is ready."After that I just have a blinking cursor (no prompt) that will allow me to type but wont accept...

Has anyone upgraded FWSM 1.1.3 to 2.2.1 in a production environment?If so, how was your experience?Did you use the beta 4.0 PDM code?If so, how was your experience with that?

Hello,We are using DHCP option 252 (wpad) to configure webbrowsers automatically. Internally this works fine. When users connect to our VPN 3005 concentrator with DHCP relay enabled it doesn't work. The concentrator uses the same DHCP server as inter...

Is SSH supported on the Catalyst 3548 platform. I'm running Version 12.0(5)WC9a - Enterprise edition.Thanks

Is it possible to do some form of IP load balancing with a PIX 506? I want to provide a VIP for 2 internal mirrored WWW servers. If anyone has done this with a PIX please let me know.Thanks,J