Other Security Subjects

Hi,I use VMS2.1, PIX Management Center, Security Monitor to monitoring syslog activity. I have 2 questions about it.1. In the syslog file the PIX IP address is always replaced with the workstation name, where the WMS is installed!2. Can I analize bac...

When we deploy new IDS sensors in various locations, we need to verify that the sensor's sniffing interface has sufficient visibility into the protected nets. In order to do this, we (security group) rely on network admins to setup SPAN, RSPAN, VACLs...

How can I config ISAKMP to run on my 3810?Is there a software upgrade path?

Hi all,Which is the difference between these two commands?static (outside,inside) 192.168.1.17 76.154.186.55 netmask 255.255.255.255 0 0static (inside,outside) 76.154.186.55 192.168.1.17 netmask 255.255.255.255 0 0 I thought the static command was bi...

hi, In the website, it states the both these 2 modules can support about 300 sensors.Is it more then 300 or less than 300?What is ideally in reality a reasonable number that can be supported without delay/lag? Base on what kind of network/sensor al...

Does anyone know the snmp oids equivalent to the below command..sh ip nat statthanks

I am trying to upgrade my FWSM on a new 6500 with an MSFC-2 I can access the FWSM from the MSFC and I can send traffic (ping) from the FWSM to the MSFC. There is only one access-list on the FWSM a "permit ip any any" Everytime I try to do a "Quick ...

What command on the Pix (v 6.3.1) clears the access-list hit counts? In the command reference the closest clear command I can find is the clear traffic, which clears traffic counters on each interface.Thanks in advance

I'm wondering if there is an ACL that can block P2P programs like Kazaa from the LAN side of router being that they can usually use port 80. Thanks

Hello, I've found that it can be a bit tedious to tune signatures from new sensor releases (go through the readme, find the new sig numbers, and filter for each of them in the IDS MC signature view.) Perhaps in a future version you could sort by si...

I have a client with Firewalls PIX 525 in your network. The firewall have:- Interface Inside to the inside network - Interface Outside to the outside network (internet, routers, etc...)- Interface DMZ1 to the DMZ network (Public servers)- Interface M...

Help Please !HQ : CP 4.1 SP4 FirewallRemote Home VPN Users: Dialup or broadband connectionsRemote Office: Secure Remote users behind a Cisco 827 dsl router (vs 12.2)Problem: Remote home vpn users have no problem, butRemote office users connect fine i...

We are using Cisco Secure IDS 3.*, is upgrading it to version 4.*, We would like to see if Cisco Secure IDS can detect Instant Messager Usage and third-party web email usage, is it possible? And how? Do we need to have custom signatures, or Cisco alr...