04-01-2003 12:14 PM - edited 03-09-2019 02:43 AM
Will PDM 2.1.1 work with the new PIX OS image 6.3.1 or must I install the 'beta' version of the new PDM?
Thanks,
Tony...
Solved! Go to Solution.
04-01-2003 05:16 PM
It'll work it just won't support all the new 6.3 features. PDM v3.0 will support all 6.3 features and should be available in May.
04-01-2003 05:16 PM
It'll work it just won't support all the new 6.3 features. PDM v3.0 will support all 6.3 features and should be available in May.
04-01-2003 08:12 PM
you will need to install the beta version of pdm.
thanks,
Syed
04-08-2003 09:39 AM
I went through a bit on new feature of pix 6.3.1 (commands).
It said that It supports logical interface;however, it does not support any example. Does it work similiar to router virtual interface ?
Could explain me and show some example please....
Thanks
R.
05-05-2003 08:49 AM
I have intalled 6.3(1) okay, but PDM 2.1(1), won't work. The sh hard shows it's there but when I try to access it, it says I need a "new image", which is what I thought the 2.1(1) was (from 2.0(2). Is PDM 3.0 available in beta? Has anyone successfully installed PDM 2.1(1) on PIX 6.3(1)?
Thanks,
Mike
05-06-2003 11:50 AM
HI.
I had the same results.
On a pix 501 I have upgraded from 6.2(2) to 6.3(1), and from PDM 2.0(2) to 2.1(1) - PDM did not work and poped up a message to install a newer version.
I have installed the beta version of PDM 3.0 and it works fine.
Yizhar
05-06-2003 01:50 PM
I had the same experience as Yizhar described.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide