02-10-2019 07:58 PM - edited 07-05-2021 09:49 AM
We are happy to announce the second refresh of 8.8MR2 Interim build (8.8.114.132) for PRODUCTION deployments.
Access Request: http://cs.co/88Mr2InterimAccess
(Within 24 hours access to software download will be given)
Software Image Download: http://cs.co/88MR2ImageRepository
[NOTE: Please make sure to use Aspera Client to download files, if downloading for the first time from shares.cisco.com you will be prompted to install Aspera Client on top of Website]
Feedback Form: http://cs.co/88MR2Feedback
Base Code: 8.8.111.0
Special Build: 8.8.114.132
8.8.114.132
CSCvi06408 |
Wave 1 AP failed to send DHCP packet to wired side under VLAN Override |
CSCvj71928 |
Cisco Aironet 1560, 1815, 2800 and 3800 Series Access Point Console Brute Force Protection |
CSCvk41603 |
WLC - Unable to add/delete DCA channels in RF-Profile while Channel width configured as 80 MHz. |
CSCvk68688 |
Client traffic seen on the 5508 Standby Hot WLC causing mac flapping on switch |
CSCvm73244 |
AP3800 in sniffer mode not capturing ACK,RTS in 8.7 and 8.8 CSCvf74377 |
CSCvn04046 |
Cisco 2800,3800 AP does not map the DSCP to the correct WMM UP Value for FlexConnect Local Switching |
CSCvn07126 |
Cisco FlexConnect - Cisco 2802 AP's lowers the priority UP on QoS on the downlink transmit |
CSCvn23565 |
Cisco 702w AP enables POE in LAN 4 before joining Cisoc WLC after reboot |
CSCvn25524 |
Throughput is low with Port 2 with 1 Gig SFP on 8540/5520 |
CSCvn27144 |
Unable to restore 802.11ac MCS parameter |
CSCvn47094 |
CLI not taking all the commands sent via "paste" |
CSCvn49888 |
702, 1532 AP has tracebacks and beacons stuck with load 8.5.140.0 |
CSCvn50968 |
Invalid web-auth https-redirect command in startup-config |
CSCvn53514 |
AP Syslog Facility does not work on IOS AP |
CSCvn66715 |
3800 AP stops passing traffic under client with Interl NIC 8260/8265 load in MU-MIMO deployment |
CSCvn80147 |
BPDU frames are forwarded by the COS AP causing the switch to AP err-disabling port |
CSCvn98598 |
FT 802.1x clients are not able to authenticate to COS AP after Master AP failover |
CSCvo02206 |
Frequent DFS detection - MVL DFS fix |
CSCvo04251 |
dot1x_aaa_eapresp_supp: sending MDNS request to ISE flooding when running "debug client [macaddr]" |
CSCvo05093 |
WLC crash with task name radiusTransportThread |
CSCvo06832 |
Sensor test failed using Open as well as EAP authentication |
8.8.114.108
CSCvi77141 |
HA_send_usmDbSpamSetRadSlotBand, ErrType:Apply Config failed on Standby |
CSCvi82746 |
Cisco controller reloads unexpectedly with Task Name SISF BT Process |
CSCvj48316 |
AP3700: process "QoS stats process" causes unexpected reloads |
CSCvk42388 |
8.3 Flex connect Group is not showing all the APs using GUI |
CSCvm84941 |
Cisco 1600, 1700 APs: memory leak due to packets accumulation |
CSCvn17267 |
702AP: WGB is disconnectig from root AP 'parent lost: Too many retries' RTS when root AP is offchanl |
CSCvn20446 |
Wireless client moves from local switching SSID to central switching SSID DHCP traffic gets dropped |
CSCvn32314 |
Alpha: wcpd crashed seen on 8.8.114.54 |
CSCvk79597 |
Frequent DFS detection |
CSCvn42184 |
8.8MR2:"/usr/sbin/nginx-helper: line 115: retry++: not found" flooding on 1562 ME WLC Console |
CSCvn54782 |
IGMP snooping needs to be enabled for Local Mode Local switching RLAN. |
CSCvn55904 |
WLC modified FlexACLs rules are not populated on the Flex AP |
CSCvn61436 |
Cisco 5520 controller reloads unexpectedly on taskname : NFV9_Task |
CSCvn66293 |
3802 AP relays CDP Packets from wireless devices using Cisco IP Communicator to the switch |
CSCvn68423 |
Passive client config is lost upon WLC Reload or HA failover |
CSCvn68501 |
WLC LSC : Device certificate can't be installed and showing as "Not Present" |
CSCvn71004 |
WLC Mbuf allocation problem / Mbuf Max reached |
8.8.114.94
CSCvi84734 |
Cisco 702w AP: client intermittently cannot connect- decrypt errors |
|
CSCvj97602 |
WLC Client RSSI and SNR values to be updated as part of Assoc & reassoc request processing |
|
CSCvk36887 |
Some clients cannot associate because their entry is not getting deleted at the WLC. |
|
CSCvm11060 |
WLC: After soft-roam of client, client is not able to see new Apple TV from associated AP-Grp VLAN |
|
CSCvm51648 |
Cisco WLC open auth guest clients unable to pass traffic and PEM state struck in STATICIP_NOL3SEC |
|
CSCvm60915 |
Cisco 3800 AP stops passing traffic under client load in MU-MIMO deployment |
|
CSCvm62619 |
Cisco controller reloads unexpectedly with task emweb after 'debug flexconnect' command is typed |
|
CSCvm69246 |
Cisco controller applying wrong interface policy to re-associated client after SSO |
|
CSCvm80592 |
Cisco 2800 AP reloads unexpectedly with ERROR TAMD device 'ap-tam' heartbeat failure |
|
CSCvm83223 |
AP1832: Kernel panic: PC is at _raw_spin_lock+0x44/0x84 |
|
CSCvm90337 |
Cisco 18xx APs unexpectedly reload due to 'radio failure(radio recovery failed)' |
|
CSCvn00987 |
AP group NTP config should take precedence |
|
CSCvn03560 |
Decrypt errors seen on Cisco 702 AP |
|
CSCvn05881 |
Phone 8821 has roaming issues with 2802/3802 access points MIC mismatch |
|
CSCvn11947 |
Cisco 1815w:RLAN port'traffic will get stuck at TX direction after end device restarts several times |
|
CSCvn13314 |
3802/2802: Default SSID "IP Cheetah" broadcasted during AP boot up |
|
CSCvn18615 |
Ap's couldn't authenticate with ISE 2.5.0.311 when eap method is set as EAP-FAST |
|
CSCvn27111 |
Alpha WLC crashed due "pmalloc detected memory corruption spamAP Task4 " on 8.8.114.54 |
|
CSCvn27902 |
%SAFEC-3-SAFEC_ERROR observed while decoding iPSK key from radius |
|
CSCvn41979 |
RLAN port is getting an IP address from native VLAN while AP boot for few seconds |
|
CSCvn68752 |
1542/1562 Failed to get ARP entry for WLC |
02-10-2019 08:57 PM
thanks for the info
02-10-2019 09:36 PM - edited 02-10-2019 09:40 PM
Are CSCvo05093 & CSCvo04251 going to be included?
02-11-2019 03:29 AM
02-12-2019 10:43 PM
@Sudhagar Singh wrote:
Both are fixed already.
CSCvo05093 - Will be part of the next interim refresh.
CSCvo04251 - Will be part of the future interim refresh.
If CSCvo05093 isn't included in 8.8MR2 release then I'll need to regularly reboot the controller (every 10 days).
CSCvo04251 is important because if this doesn't get fixed in 8.8MR2 there is no way I can perform a client debug because my entire screen gets spammed.
Both of the bugs were not present in 8.5.135.0.
03-07-2019 01:42 AM
02-12-2019 03:14 PM
Can you confirm that AS_7500_8_8_114_108.aes will work on the 5520 series WLC's?
02-12-2019 07:11 PM
That is the correct image to use on the 5520
02-13-2019 02:05 AM
02-26-2019 10:55 PM
03-07-2019 01:51 AM
06-27-2019 01:35 AM
03-15-2019 06:50 AM
My system was previously on version 8.8.110.61. But the upgrade to 8.8.114.132 doesn't work, it still shows that I am on version 8.8.110.61. Tried multiple times to upgrade through TFTP, never worked.
03-18-2019 05:58 AM
03-31-2019 01:16 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide