Routers - Small Business

Hi There,I'm a relative newbie to more advanced networking but have managed to get our small office IP PBX running over a SIP Trunk. The only real problem we are having is choppy outgoing audio when there is other heavy outgoing traffic on the networ...

I have my router connected to a DSL modem through a radio link.  The radio link seems to be solid- a transparent bridge- but i get an NSD fail and lose the connection.  Does anyone have any ideas.  I am thinking it is something in the modem but am no...

I have an RV220W, with two VLANs,VLAN 1 ID: 1 IP Range: 192.168.1.1 Subnet Mask 255.255.255.0VLAN 2ID: 10 IP Range: 10.0.1.0 Subnet mask 255.0.0.0I thought that I was trying to do something simple - but obviously I can't figure it out.Right now, both...

Hello,I  have the a problem, when I do a upgrade of a SMB RV042 and the PC that contain the upgrade file is in the same  segment of the RV042 the upgrades is succesfull, but when the PC is in  another subnet, upgrade fails.There are conectivity betwe...

                   Hello Gents, my cisco RV 120W VPN router have a problem with VPN connectivity. I can establish IPSEC connection to my office (Net to Net), but after some time i can not ping servers thru VPN tunnel and there no connectivity to my o...

We have 2 RV220W Routers installed in seperate offices. We are attempting to setup a IPSec tunnel between the two sites. So far we have been unsuccessful in getting this to work.On both sides, we are getting a successful connection established, but n...

I need help for enabling log on SRP521W vers. 1.01.26. As you can see in this imageI am not able to define log list and to see the log: what's wrong?

I am trying to set up DDNS for my network. Right now there are only RV180W for DDNS providers (DynDNS, TZO, and 3322).I wanted to use a free DDNS provider, however DynDNS and TZO are now pay only (or only a short free trial via credit card). 3322 see...

Our VLAN id 2 is used only by a WLAN SSIDDefining a QoS profile as using VLAN id 2 did not work. No upper rate limitation workedOnly using the IP address range of the VLAN or the SSID appeared to work. It does not appear consistent, when a VLAN id ca...

Is there any IPv6 support planned or in the works for RV082?

Is there a way to view the contents of the .exp file generated from exporting the configuration from RV082?I've got a couple of RV082 that have the same rules, but want to compare the configuration.                   

I have inserted a SIP-800 card into my CRS-8.   I inserted the SPA into the SIP.   I cannot find how I configure the SIP or the SPA.  I have spent the day reading the manual but no where do I see the commands to activate or get the SIP up and running...

Good morning all, I am having some issues getting access to my SR520 via a browser. I finally got HTTP access enabled. I do get a prompt for UN/PW, however authentication fails everytime. I tried setting up the credentials via SSH (putty),bu apparent...

Dear all,A SRP 527W is responsible for the data network in my office. But I am not able to access it.I use traceroute to confirm its IP address is “10.0.0.138”. As follows,Zengs-MacBook-Pro:~ ak4531$ traceroute www.sina.com.cntraceroute: Warning: www...