Routers - Small Business

Hello,I'm looking for a SOHO integrated PBX and Internet gateway solution and thus would like to now if:Is it possible to connect SPA400 to one of SRP527W LAN ports and thus use SRP as the Internet gateway and SPA400 as a voice gateway, then all lapt...

Hello.We use SA-520 appliance as front-end firewall connected to sattelite with about 15-20 users behind. Remote management is enabled. Lately have found after device is up for 2-3 days and I'm trying to login remotely I get certificate warning and t...

I have RV042 and it doesn't work fine with internet2 connections, cable 30MB and DSL 8MBWith Load Balance only 20MBWith Dual Wan, I have to reload many websites and too low to connect these onesI have disconnect all firewalls (from router modem and R...

Hello,I trying out the srp521w smb router and need some quidance configuraing QOS. I have enabled "Bandwidth Control' and added an entry for the voice vlan (priority high), but under QOS status i dont see any stats for the high priority queue. Anothe...

the BVI1 is the outside interface but CCA fails to recognize it as it. what is wrong with my config?TIAthis is my configversion 12.4no service padservice tcp-keepalives-inservice tcp-keepalives-outno service timestamps debug uptimeservice timestamps ...

Hi folks. I'm new to this community.I have an sr520 router/dsl modem combo device that I configured via the CCA. I had all of its configuration set (so I thought) until I plugged it into the ESW500 switch.It said it had not configured the proper swit...

Hello,I have several  WRVS4400 routers interconnected by VPN tunnels, and I would like to get  SNMP access to my routers from a monitoring software.But SNMP is reachable only from LAN side.Is any way to make that possible ? It is possible on my WRV54...

Hello,I am looking to set up a LAN that will include VoIP and a computer network.My primary concern: I can't lose my phone service due to Internet outages, so I would like Internet redundancy (two different carriers).My primary question: With about 2...

Hello togetherWe have the following issue with our WRVS4400N Version 2 SMB Router, after a undefined timespan the wireless module stop working. Every Client that is connected via the w-lan cannot access other clients, printer, servers or the internet...

HiI'm very pleased with the SRP527W router, except I have not had much success with getting it's VOIP QOS features to work well for us.  We have an IP PBX on the LAN, for which we need to reserve a certain amount of bandwidth and prioritisation for i...

Dear friends: I have a customer whom I installed two RVS4000 v1 to connect his two locations.  I am using IPSEC. His network at home runs several IP Phones and IP Cameras and he uses the VPN connection to monitor his office cameras too.  The problem ...

I have an RVS4000 that needs to be power cycled daily because it stops routing. i have checked the logs and no intrusions have occured and there is nothing stating that the routing has stopped. IPS is enabled as well as VPN. Firmware has been updated...

Hi,looking for a router of Cisco's IPSec VPN Client supported on the iPhone, I found the Cisco 4000-RVS EU and bought.However, I am having trouble setting up the VPN: Even when I set up the IPSec do not match the form data with that of the iPhone cli...

I have a WRVS4400N v2.0 "Security Router" with IPS version 1.42 which was released June 3rd of this year. The previous IPS file, 1.41 was Oct. 5th of 2009. Is the wait time for IPS updates that long? I ask because 30 days after 1.42 was applied the r...