11-18-2017 12:27 AM - last edited on 03-25-2019 11:10 PM by ciscomoderator
The latest firmware for the RV320 posted Nov 17 as 220.127.116.11. I just downloaded and attempted to update to one of our bench RV320's running 18.104.22.168. After it uploaded to the router, it kicked back a dialog saying bad firmware.
Re-downloading resulted in the same message.
Would someone check to see if there's an error in the .bin build?
Solved! Go to Solution.
01-17-2018 12:06 AM
02-15-2018 07:16 AM
Unfortunately, it hangs every 2-3 hours also on me. The problem is that I reverted to 1.3 and is also hanging few times per day.
Load balance is a mess but hangs also on link backup.
This router is nothing but a junk and Cisco doesn't care about it at all.
02-15-2018 08:05 AM
We have version 22.214.171.124 running at customers and our own shop and have had zero problems after the Cisco re-posting of this version. Suggest you contact TAC with specifics. We are running with failover mode and it works just fine and no hangs.
02-15-2018 10:07 PM - edited 02-15-2018 10:20 PM
Few month ago, I reverted to 1.3 because, with 126.96.36.199, I cannot access the router, even if the router was online. The only solution was to enable https, with all the mess regarding certificates and security messages :).
Yesterday, due to your post, I decided to give it another chance. Less than 5 hours after FW upgrade to 1.4.17, the internet connection was down, with no message or log. The router was in "Load Balance".
Is exactly what other users said, that load balance is just a bad joke.
I had, and still have, for several years, a TPLink 6020 that worked perfectly in load balance. Absolutely no problem. I bought the RV320 because the transfer speed was better but when I am leaving home for several days, I am still moving from RV320 to TPLink, even is slower, just because I am afraid of losing camera and alarm access when I am out of the city. Is this a solution, to change the cables when leaving for holiday, when I have a "modern"RV320 in my house?
Today I will give it a try with failover mode, but for me this is not a good solution because I have two ISP, one with Static IP and 100 Mbps and one with Dynamic IP with 500 Mbps.
So is a lose-lose situation: I need the Static IP for the cameras, NAS and alarm system at home but I am losing plenty of speed due to failover mode.
Do you have any specific settings of the failover? I mean, those regarding bandwidth or network service detection?
02-15-2018 11:48 PM
02-16-2018 07:09 AM
I do not know how relevant is this information but my RV320 blocks mostly during the night.
I know because my Synology NAS and also the Paradox alarm system always announces me when the connection is down.
Maybe is because of traffic, I don't know.
When the RV320 is "under pressure", during the day (PC, laptops, iPads, iPhones, etc), it works flawlessly.
Also, a very old problem, well known by users and, probably by Cisco, is the weird statistics of traffic; that abnormal value of 184...... of trillions of trillions ob bytes, that appears in minutes after traffic reset. Is an old problem, is known but nobody cares.
02-18-2018 02:55 AM
Almost 3 days with no hangout but on failover.
For me is useless, as long as I have two ISP and I cannot use them both.
I will try a load balance again.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: