08-07-2012 11:48 AM - edited 03-05-2019 06:48 AM
I have a new 3925 router and it came with 1 VWIC3-4MFT-T1/E1 card installed. I added a 2nd one and although it shows up in inventory, the interfaces do not show up in configuration in any form, interface or controllers. I used to just install a card and it would be recognized, is that no longer supported and is it platform specific or IOS specific?
Thank you
Roy
Solved! Go to Solution.
08-07-2012 11:56 AM
Configyure card type x/y E1 ot T1
08-07-2012 11:56 AM
Configyure card type x/y E1 ot T1
08-07-2012 01:03 PM
Thank you, that did it. My bad; it was right there in front of me the whole time. The router statement said,"card type needed for slot 0/1. I need to slow down and read more carefully.
Thank you
Roy
08-07-2012 02:02 PM
To slow down is always good.
Thank you for the nice rating and good luck!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: