Routing

I have configured a Two service provider BGP configuration in single router. Configuration as given as below... G_Ware#sh running-config | s routerouter bgp 64515 no synchronization bgp log-neighbor-changes network 10.103.0.0 mask 255.255.240.0 neig...

Hi all, I'm migrating from a couple of ASR 1002 routers to a couple of ASR9K Routers. This couple of Router are the Internet E-BGP Router. Most neighbor are configured under Neighbor group, but has also a specific policy applied. ES : router bgp 10...

H I there, We are trying to reproduce a problem a client has and think we can do it, if our router was configured correctly and I'm not sure how with this model. 2 windows7 pcs, each connects to the first 2 ports on the router. DHCP enabled and IP...

Good day all I am trying to configure PPPoE on a Cisco 2911 router Using an external Radius server (Ubuntu freeRadius). My configs are as below for the Cisco part. #####################################################################################...

Hi members How to perform a NAT on router 4321 whereby I have 2 public IPs and they need to NAT to the same Internal IP (Internal server)? How can it be done. Give me suggestions. Router has two WAN connections with load balancing configuration. The...

I have a switch  cisco catalyst 2960CG-8TC-L (mini switch), and I can't connect to it with telnet because there is no login local on it, and I can't write on this switch this command. Does someone know the command of this switch for enable login loca...

I have setup traffic shaping to limit the internet bandwidth on 3 vlans (subnets), it is working but it is also limiting these 3 Vlans LAN bandwidth, like, i setup 10Mbps internet limit which is working fine, it is also limiting 1G Lan bandwidth to 1...

Hello, I have two core routers (R1 and R2) in the main location and I am running HSRP between them. I want to build a GRE Tunnel with branch router (R3) using HSRP virtual address. A simple diagram is attached for reference. Can I use the HSRP addres...

Hi, We have upgraded our ASA 5515 to 9.1 and we have lost SSH to it. We have seen the same behavior on two different ASA 5515 after upgrade. Anyone aware of this issue or have experienced similar issue with ASA 5515 where you have lost the SSH comple...

Hi fellas,I just configured ip route and I can't ping from host to AboveNet. the diagram is like,Host - Router - AboveNetNetwork for host-Router is 209.249.194.32/27 and Router-AboveNet is 64.125.71.0/30 and please check the output below,S*    0.0.0....

hi,  could you please help out, how to verify cisco product serial number, that its genuine or refurbished?