Routing

:-oI have a new 2960G switch setup and I'm unable to ping my laptop, which is connected to a hub via int g0/1 of the switch? I can ping the switch from my lapton, but i can't ping my laptop from the switch ? I've double checked that there is no ACL e...

Hello, In my organization an application administrator tells me that a new given application/server is known not to work with IGMPv3. Therefore application administrator asks me to change respective vlan the application is running from IGMPv3 to IGMP...

Imagine I want to find out what type of queries (IGMPv1, v2 or v3) receivers are sending.I am afraid that if I do 'debug ip igmp' I may overhelm the router.So I thought about limiting the debug ip igmp output by filtering using access-list or at leas...

In service software upgrade must be supported and it should be possible to upgarade the router 7600  from one OS version to another without a downtime.RegardsSandeep Chugh

Hi Everyone.  is it possible to do an equivalent to a rate-limit (CAR) on a C4507r?  What im looking to do is be able to have various rate-limits on a various vlan for both upload and download.  I've used the rate-limit (CAR) on a router but on the C...

Sorry to be over the top, but I've wiped the flash on my cisco 877 by accident and I need to get back and up and running ASAP.Any help

Hi,My name is Arik and I want to connect two routers with WIC-1-ADSL Interface.Both routers are with this interface and connected directly to each other with RJ11 phone cable.What is the configuration that I need to use to connect them, Right now i d...

Greetings,I have a 2821 router with a T1 to ISP A, and a new ethernet connection to a cable provider.We are using public IPs from the T1 provider, and want to route some of this traffic to the cable provider.  Since the cable provider cannot route IS...

I am working at a client site whom has 2 T1's bundled together into a multilink on their 3845 ISR.The Multilink is part of an MPLS circuit and uses Classes of Service to prioritize traffic and assign bandwidth to classes.I was reading some old docume...

Morning Pros,I have one way to check out the  path MTU from your pc to  any Internet site, use ping command,anyone has other way, or software,thank you for share,Yang

I have cisco 7201 (Version 12.4.20T)  with on-board  4 GigabitEthernet interfaces:      GigabitEthernet 0/0 and GigabitEthernet 0/1 bundled in one logical link  PortChannel 1 and connected to Сisco 3750;      GigabitEthernet 0/2 and GigabitEthernet 0...