Routing

Hi all,I have had a Cisco 7206VXR with NPE-G1 router running 12.4(22)T AdvIP Serv. crash twice in the last week. My syslog indicates a memory allocation failure / no memory error. The router runs a full BGP table. I was hoping somebody could point ou...

Hi,I wanted to plugin a VWIC-1MFT-E1 card in the empty slot.Router doesn't see the new card!It complains about it:...cisco 2610XM (MPC860P) processor (revision 0x301) with 126976K/4096K bytes of m.Processor board ID FOC082701F7 (221627690)M860 proces...

We are streching vlans on our WAN Layer between 2 of our datacenters terminating on 6509 via DWDM. The reason why so we can have firewalls in HA pair, one per datacenter connected via the layer vlan streched between datacenters also loadbalancers and...

Hi,is there a command with the cli to cehck all the routing tables also the IPSEC L2L (because if I need to configure a new VPN L2L or a new route need to check the all configuration !!!)With the "sh ip route" I cannot see the VPN IPSEC L2L (or the C...

Can we use NM-2CE1T1-PRI & HWIC-2CE1T1-PRI , both modules in 3845 Router simultaneously . Is there any limitation for using the same or any performance degradation

I am attempting to get a point to point GRE tunnel set up for backup internet access. Here is some backgorund information on what I am trying to do (if it is even possible):We have a server co-location what will let us use their internet POP for a ba...

My 857 ver 12.3(8r)Y14 doesn't use acl in for anything inbound from public side rather pat translations. This works for one port translation to a server on the trusted side but not for another port to the same server. When I add an inbound acl for pu...

What's the syntax on the C7500 to see the #show ifindex.Thanks.

We have some spoke sites connected to HUB location. All the sites are having 2 E1 links which are bundled via Multilink. The issue is when we pump traffic on it the CRC and errors on both the links at spoke site increases and when we unbundled the li...

my problem is one side vc is up and the other side was down when I configure EoMPLS the configuration like thisME-6524interface GigabitEthernet1/13 switchport switchport access vlan 101 switchport trunk encapsulation dot1q switchport mode trunkendint...

Hi expertsActually I have the the attached scenariothe problem is :IPDSLAM does not support RADIUS and I want all our ADSL subscribers to authenticated on RADIUS SERVERIs there any way to force IPDSLAM to send authentication request to 7206 as LNS th...